Hi Rob,
On 2016/11/29 23:34, Rob Herring wrote:
On Sun, Nov 13, 2016 at 10:11 PM, Shawn Lin <shawn.lin@xxxxxxxxxxxxxx> wrote:
Rockchip's RC outputs 100MHz reference clock but there are
two methods for PHY to generate it.
(1)One of them is to use system PLL to generate 100MHz clock and
the PHY will relock it and filter signal noise then outputs the
reference clock.
(2)Another way is to share Soc's 24MHZ crystal oscillator with
PHY and force PHY's DLL to generate 100MHz internally.
When using case(2), the exit from L0s doesn't work fine occasionally
due to the broken design of RC receiver's logical circuit. So even if
we use extended-synch, it still fails for PHY to relock the bits from
FTS sometimes. This will hang the system.
Maybe we could argue that why not use case(1) to avoid it? The reason
is that as we could see the reference clock is derived from system PLL
and the path from it to PHY isn't so clean which means there are some
noise introduced by power-domain and other buses can't be filterd out
by PHY and we could see noise from the frequency spectrum by oscilloscope.
This makes the TX compatibility test a little difficult to pass the spec.
So case(1) and case(2) are both used indeed now. If using case(2), we
should disable RC's L0s support, and that is why we need this property to
indicate this quirk.
Also after checking quirk.c, I noticed there is already a quirk for
disabling L0s unconditionally, quirk_disable_aspm_l0s. But obviously we
shouldn't do that as mentioned above that case(1) could still works fine
with L0s.
Reported-by: Jeffy Chen <jeffy.chen@xxxxxxxxxxxxxx>
Cc: Brian Norris <briannorris@xxxxxxxxxxxx>
Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/pci/rockchip-pcie.txt | 2 ++
drivers/pci/host/pcie-rockchip.c | 9 +++++++++
2 files changed, 11 insertions(+)
diff --git a/Documentation/devicetree/bindings/pci/rockchip-pcie.txt b/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
index ba67b39..cfa44a7 100644
--- a/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/rockchip-pcie.txt
@@ -42,6 +42,8 @@ Required properties:
Optional Property:
- ep-gpios: contain the entry for pre-reset gpio
- num-lanes: number of lanes to use
+- quirk,aspm-no-l0s: RC won't support ASPM L0s. This property is needed if
quirk is not a vendor. Drop it.
I guess you want me to drop the "quirk" prefix and just use
aspm-no-l0s instaed?
+ using 24MHz OSC for RC's PHY.
- vpcie3v3-supply: The phandle to the 3.3v regulator to use for PCIe.
- vpcie1v8-supply: The phandle to the 1.8v regulator to use for PCIe.
- vpcie0v9-supply: The phandle to the 0.9v regulator to use for PCIe.
--
Best Regards
Shawn Lin
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
