Hi Shawn, > -----Original Message----- > From: Shawn Guo [mailto:shawnguo@xxxxxxxxxx] > Sent: Sunday, September 18, 2016 8:52 AM > To: Po Liu > Cc: linux-pci@xxxxxxxxxxxxxxx; linux-arm-kernel@xxxxxxxxxxxxxxxxxxx; > linux-kernel@xxxxxxxxxxxxxxx; devicetree@xxxxxxxxxxxxxxx; Roy Zang; Arnd > Bergmann; Marc Zyngier; Stuart Yoder; Leo Li; M.H. Lian; Murali > Karicheri; Bjorn Helgaas; Mingkai Hu > Subject: Re: [PATCH v5 3/3] pci:aer: add support aer interrupt with none > MSI/MSI-X/INTx mode > > On Tue, Sep 13, 2016 at 12:40:59PM +0800, Po Liu wrote: > > On some platforms, root port doesn't support MSI/MSI-X/INTx in RC mode. > > When chip support the aer interrupt with none MSI/MSI-X/INTx mode, > > maybe there is interrupt line for aer pme etc. Search the interrupt > > number in the fdt file. Then fixup the dev->irq with it. > > > > Signed-off-by: Po Liu <po.liu@xxxxxxx> > > Will the new kernel work with existing/old DTB? I'm trying to > understand the dependency between driver and DTS changes. Yes, We've never use name 'intr' before. So we remove it is ok. 'aer' is a dts name for researching it's true interrupt number by kernel. This patch is first time to use name 'aer'. So it must be compatible with existing/old DTB. > > Shawn > > > --- > > changes for v5: > > - Add clear 'aer' interrup-names description > > > > .../devicetree/bindings/pci/layerscape-pci.txt | 11 +++++--- > > drivers/pci/pcie/portdrv_core.c | 31 > +++++++++++++++++++--- > > 2 files changed, 35 insertions(+), 7 deletions(-) > > > > diff --git a/Documentation/devicetree/bindings/pci/layerscape-pci.txt > > b/Documentation/devicetree/bindings/pci/layerscape-pci.txt > > index 41e9f55..101d0a7 100644 > > --- a/Documentation/devicetree/bindings/pci/layerscape-pci.txt > > +++ b/Documentation/devicetree/bindings/pci/layerscape-pci.txt > > @@ -18,8 +18,10 @@ Required properties: > > - reg: base addresses and lengths of the PCIe controller > > - interrupts: A list of interrupt outputs of the controller. Must > contain an > > entry for each entry in the interrupt-names property. > > -- interrupt-names: Must include the following entries: > > - "intr": The interrupt that is asserted for controller interrupts > > +- interrupt-names: It may be include the following entries: > > + "aer": The interrupt that is asserted for aer interrupt > > + "pme": The interrupt that is asserted for pme interrupt > > + ...... > > - fsl,pcie-scfg: Must include two entries. > > The first entry must be a link to the SCFG device node > > The second entry must be '0' or '1' based on physical PCIe > controller index. > > @@ -35,8 +37,9 @@ Example: > > reg = <0x00 0x03400000 0x0 0x00010000 /* controller > registers */ > > 0x40 0x00000000 0x0 0x00002000>; /* configuration > space */ > > reg-names = "regs", "config"; > > - interrupts = <GIC_SPI 177 IRQ_TYPE_LEVEL_HIGH>; /* > controller interrupt */ > > - interrupt-names = "intr"; > > + interrupts = <GIC_SPI 176 IRQ_TYPE_LEVEL_HIGH>, /* aer > interrupt */ > > + <GIC_SPI 177 IRQ_TYPE_LEVEL_HIGH>; /* pme interrupt */ > > + interrupt-names = "aer", "pme"; > > fsl,pcie-scfg = <&scfg 0>; > > #address-cells = <3>; > > #size-cells = <2>; > > diff --git a/drivers/pci/pcie/portdrv_core.c > > b/drivers/pci/pcie/portdrv_core.c index e9270b4..7c4943d 100644 > > --- a/drivers/pci/pcie/portdrv_core.c > > +++ b/drivers/pci/pcie/portdrv_core.c > > @@ -16,6 +16,7 @@ > > #include <linux/slab.h> > > #include <linux/pcieport_if.h> > > #include <linux/aer.h> > > +#include <linux/of_irq.h> > > > > #include "../pci.h" > > #include "portdrv.h" > > @@ -200,6 +201,28 @@ static int pcie_port_enable_msix(struct pci_dev > > *dev, int *vectors, int mask) static int init_service_irqs(struct > > pci_dev *dev, int *irqs, int mask) { > > int i, irq = -1; > > + int ret; > > + struct device_node *np = NULL; > > + > > + for (i = 0; i < PCIE_PORT_DEVICE_MAXSERVICES; i++) > > + irqs[i] = 0; > > + > > + if (dev->bus->dev.of_node) > > + np = dev->bus->dev.of_node; > > + > > + /* If root port doesn't support MSI/MSI-X/INTx in RC mode, > > + * request irq for aer > > + */ > > + if (IS_ENABLED(CONFIG_OF_IRQ) && np && > > + (mask & PCIE_PORT_SERVICE_PME)) { > > + ret = of_irq_get_byname(np, "aer"); > > + if (ret > 0) { > > + irqs[PCIE_PORT_SERVICE_AER_SHIFT] = ret; > > + if (dev->irq) > > + irq = dev->irq; > > + goto no_msi; > > + } > > + } > > > > /* > > * If MSI cannot be used for PCIe PME or hotplug, we have to use > @@ > > -225,11 +248,13 @@ static int init_service_irqs(struct pci_dev *dev, > int *irqs, int mask) > > irq = dev->irq; > > > > no_msi: > > - for (i = 0; i < PCIE_PORT_DEVICE_MAXSERVICES; i++) > > - irqs[i] = irq; > > + for (i = 0; i < PCIE_PORT_DEVICE_MAXSERVICES; i++) { > > + if (!irqs[i]) > > + irqs[i] = irq; > > + } > > irqs[PCIE_PORT_SERVICE_VC_SHIFT] = -1; > > > > - if (irq < 0) > > + if (irq < 0 && irqs[PCIE_PORT_SERVICE_AER_SHIFT] < 0) > > return -ENODEV; > > return 0; > > } > > -- > > 2.1.0.27.g96db324 > > > > > > _______________________________________________ > > linux-arm-kernel mailing list > > linux-arm-kernel@xxxxxxxxxxxxxxxxxxx > > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel ��.n��������+%������w��{.n�����{���"�)�� jg��� �����ݢj����G���� ���j:+v���w�m������w�������h�����٥
