Re: [PATCH 1/2] dt-bindings: pci: add DT binding for Axis ARTPEC-6 PCIe controller

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, May 05, 2016 at 05:03:31PM -0500, Rob Herring wrote:
> On Wed, May 04, 2016 at 01:54:17PM +0200, Niklas Cassel wrote:
> > From: Niklas Cassel <niklas.cassel@xxxxxxxx>
> > 
> > This commit adds the Device Tree binding documentation that allows to
> > describe the PCIe controller found in the Axis ARTPEC-6 SoC.
> > 
> > Signed-off-by: Niklas Cassel <niklas.cassel@xxxxxxxx>
> > ---
> >  .../devicetree/bindings/pci/axis,artpec6-pcie.txt  | 45 ++++++++++++++++++++++
> >  1 file changed, 45 insertions(+)
> >  create mode 100644 Documentation/devicetree/bindings/pci/axis,artpec6-pcie.txt
> > 
> > diff --git a/Documentation/devicetree/bindings/pci/axis,artpec6-pcie.txt b/Documentation/devicetree/bindings/pci/axis,artpec6-pcie.txt
> > new file mode 100644
> > index 0000000..fdac2a2
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/pci/axis,artpec6-pcie.txt
> > @@ -0,0 +1,45 @@
> > +* Axis ARTPEC-6 PCIe interface
> > +
> > +This PCIe host controller is based on the Synopsis Designware PCIe IP
> > +and thus inherits all the common properties defined in designware-pcie.txt.
> > +
> > +Required properties:
> > +- compatible: "axis,artpec6-pcie", "snps,dw-pcie"
> > +- reg: base addresses and lengths of the pcie controller (DBI),
> > +	the phy controller, and configuration address space.
> > +- reg-names: Must include the following entries:
> > +	- "dbi"
> > +	- "phy"
> > +	- "config"
> > +- interrupts: A list of interrupt outputs of the controller. Must contain an
> > +  entry for each entry in the interrupt-names property.
> > +- interrupt-names: Must include the following entries:
> > +	- "msi": The interrupt that is asserted when an MSI is received
> > +- syscon: Should contain a link to the syscon device node.
> 
> What is the syscon for? Perhaps a name that reflects the purpose.

It's the SoC System Controller, and holds some chip-specific registers
for the Synopsys IP control, clocks and some termination variables spring
to mind. It was named sysctrl earlier, although that's not very much more
descriptive.

> Rob

/^JN - Jesper Nilsson
-- 
               Jesper Nilsson -- jesper.nilsson@xxxxxxxx
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux