Am 06.02.2016 um 16:19 schrieb Bjorn Helgaas:
> Hi Heiner,
>
> On Sat, Feb 06, 2016 at 09:09:47AM +0100, Heiner Kallweit wrote:
>> Am 06.02.2016 um 00:37 schrieb Rafael J. Wysocki:
>>> On Saturday, February 06, 2016 12:00:32 AM Heiner Kallweit wrote:
>>>> Since commit a44c386a361e "x86/PCI/ACPI: Recognize that Interrupt Line 255
>>>> means "not connected"" I get several "PCI INT not connected" warnings on
>>>> a Zotac CI321 and EHCI failes to load:
>>>
>>> That doesn't follow clearly from your report, but I'm assuming that it works
>>> correctly without that commit, right?
>>>
>> Right, w/o this commit it looks like this:
>>
>> dmesg
>> ehci-pci 0000:00:1d.0: irq 23, io mem 0xf7d1b000
>>
>> /proc/interrupts
>> IO-APIC 23-fasteoi ehci_hcd:usb3
>
> Thanks a lot for your report! This is a bit of a minefield, and I was
> worried that we'd trip over something with a44c386a361e.
>
> Oops, I think I see a problem with a44c386a361e. We're checking for
> Interrupt Line == 255 even before we try to look it up in the _PRT. I
> think we should only check Interrupt Line *after* everything else has
> failed. Can you try the patch below instead of a44c386a361e?
>
With the attached patch everything is fine. No warnings and EHCI loads properly.
Regards, Heiner
> If the patch below doesn't work, would you mind collecting the
> complete output of "lspci -vvv" and the complete dmesg logs from
> kernels with and without a44c386a361e, and putting them somewhere
> (maybe a bugzilla.kernel.org report)?
>
> Bjorn
>
>
> diff --git a/drivers/acpi/pci_irq.c b/drivers/acpi/pci_irq.c
> index d30184c..807a0a8 100644
> --- a/drivers/acpi/pci_irq.c
> +++ b/drivers/acpi/pci_irq.c
> @@ -33,6 +33,7 @@
> #include <linux/pci.h>
> #include <linux/acpi.h>
> #include <linux/slab.h>
> +#include <linux/interrupt.h>
>
> #define PREFIX "ACPI: "
>
> @@ -387,6 +388,23 @@ static inline int acpi_isa_register_gsi(struct pci_dev *dev)
> }
> #endif
>
> +static inline bool acpi_pci_irq_valid(struct pci_dev *dev, u8 pin)
> +{
> +#ifdef CONFIG_X86
> + /*
> + * On x86, Interrupt Line 0xff means "unknown" or "no connection"
> + * (PCI 3.0, Section 6.2.4, footnote on page 223).
> + */
> + if (dev->irq == 0xff) {
> + dev->irq = IRQ_NOTCONNECTED;
> + dev_warn(&dev->dev, "PCI INT %c: not connected\n",
> + pin_name(pin));
> + return false;
> + }
> +#endif
> + return true;
> +}
> +
> int acpi_pci_irq_enable(struct pci_dev *dev)
> {
> struct acpi_prt_entry *entry;
> @@ -431,11 +449,14 @@ int acpi_pci_irq_enable(struct pci_dev *dev)
> } else
> gsi = -1;
>
> - /*
> - * No IRQ known to the ACPI subsystem - maybe the BIOS /
> - * driver reported one, then use it. Exit in any case.
> - */
> if (gsi < 0) {
> + /*
> + * No IRQ known to the ACPI subsystem - maybe the BIOS /
> + * driver reported one, then use it. Exit in any case.
> + */
> + if (!acpi_pci_irq_valid(dev, pin))
> + return 0;
> +
> if (acpi_isa_register_gsi(dev))
> dev_warn(&dev->dev, "PCI INT %c: no GSI\n",
> pin_name(pin));
> diff --git a/include/linux/interrupt.h b/include/linux/interrupt.h
> index 0e95fcc..358076e 100644
> --- a/include/linux/interrupt.h
> +++ b/include/linux/interrupt.h
> @@ -125,6 +125,16 @@ struct irqaction {
>
> extern irqreturn_t no_action(int cpl, void *dev_id);
>
> +/*
> + * If a (PCI) device interrupt is not connected we set dev->irq to
> + * IRQ_NOTCONNECTED. This causes request_irq() to fail with -ENOTCONN, so we
> + * can distingiush that case from other error returns.
> + *
> + * 0x80000000 is guaranteed to be outside the available range of interrupts
> + * and easy to distinguish from other possible incorrect values.
> + */
> +#define IRQ_NOTCONNECTED (1U << 31)
> +
> extern int __must_check
> request_threaded_irq(unsigned int irq, irq_handler_t handler,
> irq_handler_t thread_fn,
> diff --git a/kernel/irq/manage.c b/kernel/irq/manage.c
> index 8411872..e79e60f 100644
> --- a/kernel/irq/manage.c
> +++ b/kernel/irq/manage.c
> @@ -1609,6 +1609,9 @@ int request_threaded_irq(unsigned int irq, irq_handler_t handler,
> struct irq_desc *desc;
> int retval;
>
> + if (irq == IRQ_NOTCONNECTED)
> + return -ENOTCONN;
> +
> /*
> * Sanity-check: shared interrupts must pass in a real dev-ID,
> * otherwise we'll have trouble later trying to figure out
> @@ -1699,9 +1702,13 @@ EXPORT_SYMBOL(request_threaded_irq);
> int request_any_context_irq(unsigned int irq, irq_handler_t handler,
> unsigned long flags, const char *name, void *dev_id)
> {
> - struct irq_desc *desc = irq_to_desc(irq);
> + struct irq_desc *desc;
> int ret;
>
> + if (irq == IRQ_NOTCONNECTED)
> + return -ENOTCONN;
> +
> + desc = irq_to_desc(irq);
> if (!desc)
> return -EINVAL;
>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
