[Jingoo's response didn't make it to the list because it contained HTML, but I incorporated it below manually] On Tue, Dec 8, 2015 at 11:28 PM, Han Jingoo wrote: > On Fri, Dec 04, 2015 at 03:02:34PM -0600, Bjorn Helgaas wrote: > > [+cc Jingoo] > > > > On Fri, Dec 04, 2015 at 02:59:06PM -0600, Bjorn Helgaas wrote: > > > On Fri, Nov 27, 2015 at 11:56:34AM +0100, Petr Štetiar wrote: > > > > It's currently not possible to use reset-gpio on board where the GPIO is > > > > active low as the code incorrectly assumes, that reset-gpio will be > > > > always active high. > > > > > > > > In my case the broken behavior was observed on Toradex Apalis SoM with > > > > Ixora base board. > > > > > > > > Signed-off-by: Petr Štetiar <ynezz@xxxxxxx> > > > > > > Applied as follows with Lucas' reviewed-by to pci/host-imx6 for v4.5, > > > thanks! > > > > Jingoo, I noticed pci-exynos.c also uses of_get_named_gpio(). Do you > > care about this issue, too, or are you content to ignore the GPIO > > flags for your "reset-gpio"? > > Sorry, I don't care about it. > Also, there is no issue with Exynos platform. OK, thanks for checking! Bjorn -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
