Am Montag, den 10.08.2015, 17:38 -0500 schrieb Bjorn Helgaas:
> On Tue, Aug 04, 2015 at 08:41:15PM +0530, Pratyush Anand wrote:
> > On Thu, Jul 23, 2015 at 8:19 PM, Lucas Stach <l.stach@xxxxxxxxxxxxxx> wrote:
> > > Allows to set up and use multiple MSI irqs per device.
> > >
> > > Signed-off-by: Lucas Stach <l.stach@xxxxxxxxxxxxxx>
>
> Thanks Lucas, I'm hoping for a little refactoring as Pratyush suggests
> and maybe a third patch to fill in the upper bytes of the message? Or
> do those look not feasible?
>
Pratyush suggestion looks okay and I have that on my TODO. Expect
updated patches shortly.
Regards,
Lucas
> Bjorn
>
> > > ---
> > > The ifdef is needed to avoid a compile error on
> > > !CONFIG_PCI_MSI, as msi_list is only part of pci_dev
> > > when the kernel is compiled with MSI support.
> > >
> > > v2: move ifdeffery inside single function
> > > ---
> > > drivers/pci/host/pcie-designware.c | 43 ++++++++++++++++++++++++++++++++++++++
> > > 1 file changed, 43 insertions(+)
> > >
> > > diff --git a/drivers/pci/host/pcie-designware.c b/drivers/pci/host/pcie-designware.c
> > > index 69486be7181e..52c600327805 100644
> > > --- a/drivers/pci/host/pcie-designware.c
> > > +++ b/drivers/pci/host/pcie-designware.c
> > > @@ -286,6 +286,9 @@ static int assign_irq(int no_irqs, struct msi_desc *desc, int *pos)
> > > }
> > >
> > > *pos = pos0;
> > > + desc->nvec_used = no_irqs;
> > > + desc->msi_attrib.multiple = order_base_2(no_irqs);
> > > +
> > > return irq;
> > >
> > > no_valid_irq:
> > > @@ -323,6 +326,45 @@ static int dw_msi_setup_irq(struct msi_controller *chip, struct pci_dev *pdev,
> > > return 0;
> > > }
> > >
> > > +static int dw_msi_setup_irqs(struct msi_controller *chip, struct pci_dev *pdev,
> > > + int nvec, int type)
> > > +{
> > > +#ifdef CONFIG_PCI_MSI
> > > + int irq, pos;
> > > + struct msi_desc *desc;
> > > + struct msi_msg msg;
> > > + struct pcie_port *pp = sys_to_pcie(pdev->bus->sysdata);
> > > +
> > > + /* MSI-X interrupts are not supported */
> > > + if (type == PCI_CAP_ID_MSIX)
> > > + return -EINVAL;
> > > +
> > > + WARN_ON(!list_is_singular(&pdev->msi_list));
> > > + desc = list_entry(pdev->msi_list.next, struct msi_desc, list);
> > > +
> >
> > Probably existing function dw_msi_setup_irq() can be re-factored and code after
> > this line can be reused from refactored function, as they are almost same.
> >
> > > + irq = assign_irq(nvec, desc, &pos);
> > > + if (irq < 0)
> > > + return irq;
> > > +
> > > + if (pp->ops->get_msi_addr)
> > > + msg.address_lo = pp->ops->get_msi_addr(pp);
> > > + else
> > > + msg.address_lo = virt_to_phys((void *)pp->msi_data);
> > > + msg.address_hi = 0x0;
> > > +
> >
> > Although, not specific to this patch, but since we are now going to have
> > ARM64 support for DW as well, so it would be nice to fill msg.address_hi
> > with upper bytes rather hard-coding as 0.
> >
> > > + if (pp->ops->get_msi_data)
> > > + msg.data = pp->ops->get_msi_data(pp, pos);
> > > + else
> > > + msg.data = pos;
> > > +
> > > + pci_write_msi_msg(irq, &msg);
> > > +
> > > + return 0;
> >
> > ~Pratyush
> --
> To unsubscribe from this list: send the line "unsubscribe linux-pci" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
Pengutronix e.K. | Lucas Stach |
Industrial Linux Solutions | http://www.pengutronix.de/ |
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
