Re: [PATCH v2 2/4] PCI: designware: Add ARM64 support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 2015/6/9 19:15, Lorenzo Pieralisi wrote:
> On Fri, Jun 05, 2015 at 09:11:30AM +0100, Zhou Wang wrote:
> 
> [...]
> 
>>>> -int dw_pcie_host_init(struct pcie_port *pp)
>>>> +int __init dw_pcie_host_init(struct pcie_port *pp)
>>>>  {
>>>>  	struct device_node *np = pp->dev->of_node;
>>>>  	struct platform_device *pdev = to_platform_device(pp->dev);
>>>>  	struct of_pci_range range;
>>>>  	struct of_pci_range_parser parser;
>>>> +	struct pci_bus *bus;
>>>>  	struct resource *cfg_res;
>>>> +	LIST_HEAD(res);
>>>>  	u32 val, na, ns;
>>>>  	const __be32 *addrp;
>>>>  	int i, index, ret;
>>>> @@ -502,15 +498,49 @@ int dw_pcie_host_init(struct pcie_port *pp)
>>>>  	val |= PORT_LOGIC_SPEED_CHANGE;
>>>>  	dw_pcie_wr_own_conf(pp, PCIE_LINK_WIDTH_SPEED_CONTROL, 4, val);
>>>>  
>>>> -#ifdef CONFIG_PCI_MSI
>>>> -	dw_pcie_msi_chip.dev = pp->dev;
>>>> -	dw_pci.msi_ctrl = &dw_pcie_msi_chip;
>>>> +#ifdef CONFIG_ARM
>>>> +	/*
>>>> +	 * FIXME: we should really be able to use
>>>> +	 * of_pci_get_host_bridge_resources on arm32 as well,
>>>> +	 * but the conversion needs some more testing
>>>> +	 */
>>>> +	if (global_io_offset < SZ_1M && pp->io_size > 0) {
>>>> +		pci_ioremap_io(global_io_offset, pp->io_base);
>>>> +		global_io_offset += SZ_64K;
>>>> +		pci_add_resource_offset(&res, &pp->io,
>>>> +					global_io_offset - pp->io_bus_addr);
>>>> +	}
>>>> +	pci_add_resource_offset(&res, &pp->mem,
>>>> +				pp->mem.start - pp->mem_bus_addr);
>>>> +	pci_add_resource(&res, &pp->busn);
>>>
>>> I don't think this #ifdef is necessary. In the spirit of 'the conversion
>>> needs some more testing', I removed it leaving just the below arm64 code.
>>>
>>> This worked on my Freescale i.MX6 Quad SABRE Lite Board, I went as far as
>>> scanning for wireless access points.
>>>
>>
>> I think it depends on which kind of PCIe device you use, if we use a PCIe device
>> with a I/O Bar, it may not work well without above code. But so far, I have not
>> met a PCIe device which must work with a I/O Bar.
> 
> There are two problems here:
> 
> 1) the io_base address you get from of_pci_get_host_bridge_resources
>    must be mapped using pci_remap_iospace. You are not doing this, so
>    even if you had a PCIe card with I/O bar it would not work on arm64
>    as the code stands. Remember that I/O space on arm/arm64 works as a
>    memory access with offset from PCI_IOBASE and that's the value you get
>    in the I/O resource. See:
> 
>    drivers/pci/host/pci-host-generic.c
>    drivers/pci/host/pci-versatile.c
>    drivers/pci/host/pci-xgene.c
> 
> 2) (1) above would sort out I/O space access for both arm and arm64 so,
>    as James said, the #ifdef is useless.
> 
> I hope this makes things clearer.
> 
> Thanks,
> Lorenzo
>

Hi Lorenzo,

Many thanks for your explanation. I have a better understanding now.
So I think we could remove #ifdef and add pci_remap_iospace after
of_pci_get_host_bridge_resources.

Regards,
Zhou

>>
>>>> +#else
>>>> +	ret = of_pci_get_host_bridge_resources(np, 0, 0xff, &res, &pp->io_base);
>>>
>>> of_pci_get_host_bridge_resources expects &pp->io_base to be a
>>> resource_size_t*, but &io_base is u64*. This generates a warning on arm
>>> with the above change. Changing the the type in
>>> drivers/pci/host/pcie-designware.h fixes this.
>>>
>>>
>>> Thanks,
>>>
>>> James
>>>
>>
>> OK, will modify this in next version.
>>
>> Best Regards and thanks again for your test,
>> Zhou
>>
>>>> +	if (ret)
>>>> +		return ret;
>>>> +#endif
>>>> +
>>>> +	bus = pci_create_root_bus(pp->dev, pp->root_bus_nr, &dw_pcie_ops,
>>>> +			      pp, &res);
>>>> +	if (!bus)
>>>> +		return -ENOMEM;
>>>> +
>>>> +#ifdef CONFIG_GENERIC_MSI_IRQ_DOMAIN
>>>> +	bus->msi = container_of(&pp->irq_domain, struct msi_controller, domain);
>>>> +#else
>>>> +	bus->msi = &dw_pcie_msi_chip;
>>>>  #endif
>>>>  
>>>> -	dw_pci.nr_controllers = 1;
>>>> -	dw_pci.private_data = (void **)&pp;
>>>> +	pci_scan_child_bus(bus);
>>>> +	if (pp->ops->scan_bus)
>>>> +		pp->ops->scan_bus(pp);
>>>>  
>>>> -	pci_common_init_dev(pp->dev, &dw_pci);
>>>> +#ifdef CONFIG_ARM
>>>> +	/* support old dtbs that incorrectly describe IRQs */
>>>> +	pci_fixup_irqs(pci_common_swizzle, of_irq_parse_and_map_pci);
>>>> +#endif
>>>> +
>>>> +	pci_assign_unassigned_bus_resources(bus);
>>>> +	pci_bus_add_devices(bus);
>>>>  
>>>>  	return 0;
>>>>  }
>>>> @@ -653,7 +683,7 @@ static int dw_pcie_valid_config(struct pcie_port *pp,
>>>>  static int dw_pcie_rd_conf(struct pci_bus *bus, u32 devfn, int where,
>>>>  			int size, u32 *val)
>>>>  {
>>>> -	struct pcie_port *pp = sys_to_pcie(bus->sysdata);
>>>> +	struct pcie_port *pp = bus->sysdata;
>>>>  	int ret;
>>>>  
>>>>  	if (dw_pcie_valid_config(pp, bus, PCI_SLOT(devfn)) == 0) {
>>>> @@ -677,7 +707,7 @@ static int dw_pcie_rd_conf(struct pci_bus *bus, u32 devfn, int where,
>>>>  static int dw_pcie_wr_conf(struct pci_bus *bus, u32 devfn,
>>>>  			int where, int size, u32 val)
>>>>  {
>>>> -	struct pcie_port *pp = sys_to_pcie(bus->sysdata);
>>>> +	struct pcie_port *pp = bus->sysdata;
>>>>  	int ret;
>>>>  
>>>>  	if (dw_pcie_valid_config(pp, bus, PCI_SLOT(devfn)) == 0)
>>>> @@ -701,64 +731,6 @@ static struct pci_ops dw_pcie_ops = {
>>>>  	.write = dw_pcie_wr_conf,
>>>>  };
>>>>  
>>>> -static int dw_pcie_setup(int nr, struct pci_sys_data *sys)
>>>> -{
>>>> -	struct pcie_port *pp;
>>>> -
>>>> -	pp = sys_to_pcie(sys);
>>>> -
>>>> -	if (global_io_offset < SZ_1M && pp->io_size > 0) {
>>>> -		sys->io_offset = global_io_offset - pp->io_bus_addr;
>>>> -		pci_ioremap_io(global_io_offset, pp->io_base);
>>>> -		global_io_offset += SZ_64K;
>>>> -		pci_add_resource_offset(&sys->resources, &pp->io,
>>>> -					sys->io_offset);
>>>> -	}
>>>> -
>>>> -	sys->mem_offset = pp->mem.start - pp->mem_bus_addr;
>>>> -	pci_add_resource_offset(&sys->resources, &pp->mem, sys->mem_offset);
>>>> -	pci_add_resource(&sys->resources, &pp->busn);
>>>> -
>>>> -	return 1;
>>>> -}
>>>> -
>>>> -static struct pci_bus *dw_pcie_scan_bus(int nr, struct pci_sys_data *sys)
>>>> -{
>>>> -	struct pci_bus *bus;
>>>> -	struct pcie_port *pp = sys_to_pcie(sys);
>>>> -
>>>> -	pp->root_bus_nr = sys->busnr;
>>>> -	bus = pci_create_root_bus(pp->dev, sys->busnr,
>>>> -				  &dw_pcie_ops, sys, &sys->resources);
>>>> -	if (!bus)
>>>> -		return NULL;
>>>> -
>>>> -	pci_scan_child_bus(bus);
>>>> -
>>>> -	if (bus && pp->ops->scan_bus)
>>>> -		pp->ops->scan_bus(pp);
>>>> -
>>>> -	return bus;
>>>> -}
>>>> -
>>>> -static int dw_pcie_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
>>>> -{
>>>> -	struct pcie_port *pp = sys_to_pcie(dev->bus->sysdata);
>>>> -	int irq;
>>>> -
>>>> -	irq = of_irq_parse_and_map_pci(dev, slot, pin);
>>>> -	if (!irq)
>>>> -		irq = pp->irq;
>>>> -
>>>> -	return irq;
>>>> -}
>>>> -
>>>> -static struct hw_pci dw_pci = {
>>>> -	.setup		= dw_pcie_setup,
>>>> -	.scan		= dw_pcie_scan_bus,
>>>> -	.map_irq	= dw_pcie_map_irq,
>>>> -};
>>>> -
>>>>  void dw_pcie_setup_rc(struct pcie_port *pp)
>>>>  {
>>>>  	u32 val;
>>>
>>>
>>> .
>>>
>>
>>
>> --
>> To unsubscribe from this list: send the line "unsubscribe linux-pci" in
>> the body of a message to majordomo@xxxxxxxxxxxxxxx
>> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>>
> 
> .
> 


--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux