On 05/01/2014 05:35 PM, Marcel Apfelbaum wrote:
When a board is added, the shpchp driver checks if there
is a mismatch between the bridge's adapter and the bus speed.
If there is, it sets the subordinate speed (if there is no device on it).
Since the speed is irrelevant when running in a VM, I suggest that
you either ignore it altogether, or "normalize" the speed of all the
devices/bridges/buses in QEMU in order to avoid any conflicts
in the first place.
Thanks, Ronen.
However, it takes the reference of the board speed from the primary bus
and not from the subordinate. If the primary bus is PCI and not PCIX/PCIe,
its speed is not updated and remains 0xff. As a result hotplug fails
with error: "Speed of bus ff and adapter 0 mismatch".
Fixed that by checking the speed against the subordinate bus.
Signed-off-by: Marcel Apfelbaum <marcel.a@xxxxxxxxxx>
Acked-by: Michael S. Tsirkin <mst@xxxxxxxxxx>
---
drivers/pci/hotplug/shpchp_ctrl.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/pci/hotplug/shpchp_ctrl.c b/drivers/pci/hotplug/shpchp_ctrl.c
index 5849927..6efc2ec 100644
--- a/drivers/pci/hotplug/shpchp_ctrl.c
+++ b/drivers/pci/hotplug/shpchp_ctrl.c
@@ -282,8 +282,8 @@ static int board_added(struct slot *p_slot)
return WRONG_BUS_FREQUENCY;
}
- bsp = ctrl->pci_dev->bus->cur_bus_speed;
- msp = ctrl->pci_dev->bus->max_bus_speed;
+ bsp = ctrl->pci_dev->subordinate->cur_bus_speed;
+ msp = ctrl->pci_dev->subordinate->max_bus_speed;
/* Check if there are other slots or devices on the same bus */
if (!list_empty(&ctrl->pci_dev->subordinate->devices))
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html