Re: [PATCH] PCI: imx6: Fix link_up detection

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Feb 13, 2014 at 11:29:46AM -0700, Troy Kisky wrote:
> On 2/12/2014 12:36 AM, Marek Vasut wrote:
> >On Wednesday, February 12, 2014 at 08:27:55 AM, Sascha Hauer wrote:
> >
> >+CC Troy Kisky, since I think he submitted something similar some time ago
> >already.
> >
> >Otherwise I agree this happens.
> >
> Sorry, I haven't submitted this yet, but was planning to today. Here's
> what would have been sent.
> 
> From 32c560d33fe2c3945d69f3396689f0abb76f7e1f Mon Sep 17 00:00:00 2001
> From: Marek Vasut <marex@xxxxxxx>
> Date: Sat, 25 Jan 2014 14:22:48 -0700
> Subject: [PATCH 1/1] pci-imx6.c: wait for retraining
> 
> This patch handles the case where the PCIe link is up and running, yet drops
> into the LTSSM training mode. The link spends short time in the LTSSM training
> mode, but the current code can misinterpret it as the link being stalled.
> Waiting for the LTSSM training to complete fixes the issue.
> 
> Signed-off-by: Marek Vasut <marex@xxxxxxx>
> Tested-by: Troy Kisky <troy.kisky@xxxxxxxxxxxxxxxxxxx>

Thanks, that works.

Tested-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>

Sascha

> ---
>  drivers/pci/host/pci-imx6.c | 47 ++++++++++++++++++++++++++++++++-------------
>  1 file changed, 34 insertions(+), 13 deletions(-)
> 
> diff --git a/drivers/pci/host/pci-imx6.c b/drivers/pci/host/pci-imx6.c
> index e8663a8..ee08250 100644
> --- a/drivers/pci/host/pci-imx6.c
> +++ b/drivers/pci/host/pci-imx6.c
> @@ -424,20 +424,40 @@ static void imx6_pcie_reset_phy(struct pcie_port *pp)
>  static int imx6_pcie_link_up(struct pcie_port *pp)
>  {
> -	u32 rc, ltssm, rx_valid;
> +	u32 rc, debug_r0, rx_valid;
> +	int count = 5;
>  	/*
> -	 * Test if the PHY reports that the link is up and also that
> -	 * the link training finished.  It might happen that the PHY
> -	 * reports the link is already up, but the link training bit
> -	 * is still set, so make sure to check the training is done
> -	 * as well here.
> +	 * Test if the PHY reports that the link is up and also that the LTSSM
> +	 * training finished. There are three possible states of the link when
> +	 * this code is called:
> +	 * 1) The link is DOWN (unlikely)
> +	 *     The link didn't come up yet for some reason. This usually means
> +	 *     we have a real problem somewhere. Reset the PHY and exit. This
> +	 *     state calls for inspection of the DEBUG registers.
> +	 * 2) The link is UP, but still in LTSSM training
> +	 *     Wait for the training to finish, which should take a very short
> +	 *     time. If the training does not finish, we have a problem and we
> +	 *     need to inspect the DEBUG registers. If the training does finish,
> +	 *     the link is up and operating correctly.
> +	 * 3) The link is UP and no longer in LTSSM training
> +	 *     The link is up and operating correctly.
>  	 */
> -	rc = readl(pp->dbi_base + PCIE_PHY_DEBUG_R1);
> -	if ((rc & PCIE_PHY_DEBUG_R1_XMLH_LINK_UP) &&
> -	    !(rc & PCIE_PHY_DEBUG_R1_XMLH_LINK_IN_TRAINING))
> -		return 1;
> -
> +	while (1) {
> +		rc = readl(pp->dbi_base + PCIE_PHY_DEBUG_R1);
> +		if (!(rc & PCIE_PHY_DEBUG_R1_XMLH_LINK_UP))
> +			break;
> +		if (!(rc & PCIE_PHY_DEBUG_R1_XMLH_LINK_IN_TRAINING))
> +			return 1;
> +		if (!count--)
> +			break;
> +		dev_dbg(pp->dev, "Link is up, but still in training\n");
> +		/*
> +		 * Wait a little bit, then re-check if the link finished
> +		 * the training.
> +		 */
> +		usleep_range(1000, 2000);
> +	}
>  	/*
>  	 * From L0, initiate MAC entry to gen2 if EP/RC supports gen2.
>  	 * Wait 2ms (LTSSM timeout is 24ms, PHY lock is ~5us in gen2).
> @@ -446,15 +466,16 @@ static int imx6_pcie_link_up(struct pcie_port *pp)
>  	 * to gen2 is stuck
>  	 */
>  	pcie_phy_read(pp->dbi_base, PCIE_PHY_RX_ASIC_OUT, &rx_valid);
> -	ltssm = readl(pp->dbi_base + PCIE_PHY_DEBUG_R0) & 0x3F;
> +	debug_r0 = readl(pp->dbi_base + PCIE_PHY_DEBUG_R0);
>  	if (rx_valid & 0x01)
>  		return 0;
> -	if (ltssm != 0x0d)
> +	if ((debug_r0 & 0x3f) != 0x0d)
>  		return 0;
>  	dev_err(pp->dev, "transition to gen2 is stuck, reset PHY!\n");
> +	dev_dbg(pp->dev, "debug_r0=%08x debug_r1=%08x\n", debug_r0, rc);
>  	imx6_pcie_reset_phy(pp);
> -- 
> 1.8.1.2
> 
> 
> 

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux