Currently, if device power state != PCI_D0, we still initialize device MSI/MSIX, but we won't write the MSI message to device MSI/MSIX registers. It's weird, we don't configure MSI/MSIX registers properly, but pci_enable_msi() or pci_enable_msix() return success, and even these registers will never be updated later. So I think it should return error if device power state != PCI_D0. Signed-off-by: Yijing Wang <wangyijing@xxxxxxxxxx> Acked-by: Ben Hutchings <bhutchings@xxxxxxxxxxxxxx> --- v1->v2: keep __write_msi_msg() function device power state statement, because Ben Hutchings point out this function may be called during device in D3 state to set irq affinity. We should not touch that. --- drivers/pci/msi.c | 6 +++--- 1 files changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/pci/msi.c b/drivers/pci/msi.c index d5f90d6..604265c 100644 --- a/drivers/pci/msi.c +++ b/drivers/pci/msi.c @@ -831,7 +831,7 @@ int pci_enable_msi_block(struct pci_dev *dev, unsigned int nvec) int status, maxvec; u16 msgctl; - if (!dev->msi_cap) + if (!dev->msi_cap || dev->current_state != PCI_D0) return -EINVAL; pci_read_config_word(dev, dev->msi_cap + PCI_MSI_FLAGS, &msgctl); @@ -862,7 +862,7 @@ int pci_enable_msi_block_auto(struct pci_dev *dev, unsigned int *maxvec) int ret, nvec; u16 msgctl; - if (!dev->msi_cap) + if (!dev->msi_cap || dev->current_state != PCI_D0) return -EINVAL; pci_read_config_word(dev, dev->msi_cap + PCI_MSI_FLAGS, &msgctl); @@ -955,7 +955,7 @@ int pci_enable_msix(struct pci_dev *dev, struct msix_entry *entries, int nvec) int status, nr_entries; int i, j; - if (!entries || !dev->msix_cap) + if (!entries || !dev->msix_cap || dev->current_state != PCI_D0) return -EINVAL; status = pci_msi_check_device(dev, nvec, PCI_CAP_ID_MSIX); -- 1.7.1 -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
