In http://www.mail-archive.com/linux-usb@xxxxxxxxxxxxxxx/msg07976.html Ulrich reported that his USB3 cardreader does not work reliably when connected to the USB3 port. It turns out that USB3 controller failed to be waken up when plugging in the USB3 cardreader. Further experiment found that the USB3 host controller can only be waken up via polling, while not via PME interrupt. But if the PCIe port that the USB3 host controller is connected is suspended, we can not poll the USB3 host controller because its config space is not accessible if the PCIe port is put into low power state. To solve the issue, the PCIe port will not be suspended if any subordinate device need PME polling. Reported-by: Ulrich Eckhardt <usb@xxxxxxxxxxxxxxx> Signed-off-by: Huang Ying <ying.huang@xxxxxxxxx> Tested-by: Sarah Sharp <sarah.a.sharp@xxxxxxxxxxxxxxx> Cc: stable@xxxxxxxxxxxxxxx # 3.6+ --- drivers/pci/pcie/portdrv_pci.c | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-) --- a/drivers/pci/pcie/portdrv_pci.c +++ b/drivers/pci/pcie/portdrv_pci.c @@ -134,10 +134,26 @@ static int pcie_port_runtime_resume(stru return 0; } +static int pci_dev_pme_poll(struct pci_dev *pdev, void *data) +{ + int *pme_poll = data; + *pme_poll = *pme_poll || pdev->pme_poll; + return 0; +} + static int pcie_port_runtime_idle(struct device *dev) { + struct pci_dev *pdev = to_pci_dev(dev); + int pme_poll = false; + + /* + * If any subordinate device needs pme poll, we should keep + * the port in D0, because we need port in D0 to poll it. + */ + pci_walk_bus(pdev->subordinate, pci_dev_pme_poll, &pme_poll); /* Delay for a short while to prevent too frequent suspend/resume */ - pm_schedule_suspend(dev, 10); + if (!pme_poll) + pm_schedule_suspend(dev, 10); return -EBUSY; } #else -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
