Hi Minda
On Mon, 17 Mar 2025 at 07:53, Minda Chen <minda.chen@xxxxxxxxxxxxxxxx> wrote:
>
>
>
> >
> > The events_bitmap initialization in starfive_pcie_probe() previously masked out
> > the PLDA_AXI_DOORBELL and PLDA_PCIE_DOORBELL events.
> >
> > These masking has been removed, allowing these events to be included in the
> > bitmap. With this change ensures that all interrupt events are properly
> > accounted for and may be necessary for handling doorbell events in certain use
> > cases.
> >
> > PCIe Doorbell Events: These are typically used to notify a device about an event
> > or to trigger an action. For example, a host system can write to a doorbell
> > register on a PCIe device to signal that new data is available or that an
> > operation should start12.
> >
> > AXI-PCIe Bridge: This bridge acts as a protocol converter between AXI
> > (Advanced eXtensible Interface) and PCIe (Peripheral Component Interconnect
> > Express) domains. It allows transactions to be converted and communicated
> > between these two different protocols3.
> >
> > Fixes: 39b91eb40c6a ("PCI: starfive: Add JH7110 PCIe controller")
> > Cc: Minda Chen <minda.chen@xxxxxxxxxxxxxxxx>
> > Signed-off-by: Anand Moon <linux.amoon@xxxxxxxxx>
> > ---
> > v2: new patch
> > ---
> > drivers/pci/controller/plda/pcie-starfive.c | 4 +---
> > 1 file changed, 1 insertion(+), 3 deletions(-)
> >
> > diff --git a/drivers/pci/controller/plda/pcie-starfive.c
> > b/drivers/pci/controller/plda/pcie-starfive.c
> > index e73c1b7bc8efc..d2c2a8e039e10 100644
> > --- a/drivers/pci/controller/plda/pcie-starfive.c
> > +++ b/drivers/pci/controller/plda/pcie-starfive.c
> > @@ -410,9 +410,7 @@ static int starfive_pcie_probe(struct platform_device
> > *pdev)
> > plda->host_ops = &sf_host_ops;
> > plda->num_events = PLDA_MAX_EVENT_NUM;
> > /* mask doorbell event */
> > - plda->events_bitmap = GENMASK(PLDA_INT_EVENT_NUM - 1, 0)
> > - & ~BIT(PLDA_AXI_DOORBELL)
> > - & ~BIT(PLDA_PCIE_DOORBELL);
> > + plda->events_bitmap = GENMASK(PLDA_INT_EVENT_NUM - 1, 0);
> > plda->events_bitmap <<= PLDA_NUM_DMA_EVENTS;
> > ret = plda_pcie_host_init(&pcie->plda, &starfive_pcie_ops,
> > &stf_pcie_event);
> > --
> > 2.48.1
>
> Hi Anand
> Mask the door bell interrupt is required. In some case, ( eg :NVMe read/write mass data) found error.
Thank you for your review comments.
I have tested using the Starfive Vision Five 2 board with a Samsung NVMe drive
and did not encounter any data read/write errors.
However, we can consider dropping this patch if there are issues with
other development boards.
I am also available to test with different NVMe modules if needed.
Thanks
-Anand
