On Wed, Feb 26, 2025 at 06:13:58PM +0530, Sai Krishna Musham wrote: > Add GPIO-based control for the PCIe Root Port PERST# signal. > > According to section 2.2 of the PCIe Electromechanical Specification > (Revision 6.0), PERST# signal has to be deasserted after a delay of > 100 ms (TPVPERL) to ensure proper reset sequencing during PCIe > initialization. > > Adapt to use the GPIO framework and make reset optional to keep DTB > backward compatibility. > > Signed-off-by: Sai Krishna Musham <sai.krishna.musham@xxxxxxx> > --- > This patch depends on the following patch series. > https://lore.kernel.org/all/20250217072713.635643-3-thippeswamy.havalige@xxxxxxx/ > > Changes for v2: > - Make the request GPIO optional. > - Correct the reset sequence as per PERST# > - Update commit message > --- > drivers/pci/controller/pcie-xilinx-cpm.c | 23 +++++++++++++++++++++++ > 1 file changed, 23 insertions(+) > > diff --git a/drivers/pci/controller/pcie-xilinx-cpm.c b/drivers/pci/controller/pcie-xilinx-cpm.c > index 81e8bfae53d0..aa0c61d30049 100644 > --- a/drivers/pci/controller/pcie-xilinx-cpm.c > +++ b/drivers/pci/controller/pcie-xilinx-cpm.c > @@ -6,6 +6,8 @@ > */ > > #include <linux/bitfield.h> > +#include <linux/delay.h> > +#include <linux/gpio/consumer.h> > #include <linux/interrupt.h> > #include <linux/irq.h> > #include <linux/irqchip.h> > @@ -568,8 +570,29 @@ static int xilinx_cpm_pcie_probe(struct platform_device *pdev) > struct device *dev = &pdev->dev; > struct pci_host_bridge *bridge; > struct resource_entry *bus; > + struct gpio_desc *reset_gpio; > int err; > > + /* Request the GPIO for PCIe reset signal */ > + reset_gpio = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_HIGH); > + if (IS_ERR(reset_gpio)) { > + dev_err(dev, "Failed to request reset GPIO\n"); > + return PTR_ERR(reset_gpio); > + } > + > + /* Assert the reset signal */ > + gpiod_set_value(reset_gpio, 1); > + > + /* > + * As per section 2.2 of the PCI Express Card Electromechanical > + * Specification (Revision 6.0), the deassertion of the PERST# signal > + * should be delayed by 100 ms (TPVPERL). > + */ > + msleep(100); Use PCIE_T_PVPERL_MS. The comment at that #define is probably enough. > + /* Deassert the reset signal */ > + gpiod_set_value(reset_gpio, 0); > + > bridge = devm_pci_alloc_host_bridge(dev, sizeof(*port)); > if (!bridge) > return -ENODEV; > -- > 2.44.1 >
