If a PCI device is put into D3_cold by acpi_bus_set_power(), the message printed by acpi_pci_set_power_state() says that its power state has been changed to D4, which doesn't make sense. In turn, if the device is put into D3_hot, the message says just "D3" without specifying which variant of D3 it is. Fix that by using an array of state names corresponding to the PCI device power states instead of building the state name from the numeric value corresponding to the given state directly. Signed-off-by: Rafael J. Wysocki <rjw@xxxxxxx> --- drivers/pci/pci-acpi.c | 14 +++++++++++--- 1 file changed, 11 insertions(+), 3 deletions(-) Index: linux/drivers/pci/pci-acpi.c =================================================================== --- linux.orig/drivers/pci/pci-acpi.c +++ linux/drivers/pci/pci-acpi.c @@ -265,9 +265,17 @@ static int acpi_pci_set_power_state(stru error = acpi_bus_set_power(handle, state_conv[state]); } - if (!error) - dev_printk(KERN_INFO, &dev->dev, - "power state changed by ACPI to D%d\n", state); + if (!error) { + static const char *state_name[] = { + [PCI_D0] = "D0", + [PCI_D1] = "D1", + [PCI_D2] = "D2", + [PCI_D3hot] = "D3hot", + [PCI_D3cold] = "D3cold" + }; + dev_info(&dev->dev, "power state changed by ACPI to %s\n", + state_name[state]); + } return error; } -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html