On Fri, Dec 20, 2024 at 06:50:50PM +0900, Damien Le Moal wrote: > This patch series implements an NVMe target driver for the PCI transport > using the PCI endpoint framework. > > The first 5 patches of this series move and cleanup some nvme code that > will be reused in following patches. > > Patch 6 introduces the PCI transport type to allow setting up ports for > the new PCI target controller driver. Patch 7 to 10 are improvements of > the target core code to allow creating the PCI controller and processing > its nvme commands without the need to rely on fabrics commands like the > connect command to create the admin and I/O queues. > > Patch 11 relaxes the SGL check in nvmet_req_init() to allow for PCI > admin commands (which must use PRPs). > > Patches 12 to 16 improve the set/get feature support of the target code > to get closer to achieving NVMe specification compliance. These patches > though do not implement support for some mandatory features. > > Patch 17 is the main patch which introduces the NVMe PCI endpoint target > driver. This patch commit message provides and overview of the driver > design and operation. > > Finally, patch 18 documents the NVMe PCI endpoint target driver and > provides a user guide explaning how to setup an NVMe PCI endpoint > device. > > The patches are base on Linus 6.13-rc3 tree. > > This driver has been extensively tested using a Radxa Rock5B board > (RK3588 Arm SoC). Some tests have also been done using a Pine Rockpro64 > board. However, this board does not support DMA channels for the PCI > endpoint controller, leading to very poor performance. > > Using the Radxa Rock5b board and setting up a 4 queue-pairs controller > with a null-blk block device loop target, performance was measured using > fio as follows: > > +----------------------------------+------------------------+ > | Workload | IOPS (BW) | > +----------------------------------+------------------------+ > | Rand read, 4KB, QD=1, 1 job | 14.3k IOPS | > | Rand read, 4KB, QD=32, 1 job | 80.8k IOPS | > | Rand read, 4KB, QD=32, 4 jobs | 131k IOPS | > | Rand read, 128KB, QD=32, 1 job | 16.7k IOPS (2.18 GB/s) | > | Rand read, 128KB, QD=32, 4 jobs | 17.4k IOPS (2.27 GB/s) | > | Rand read, 512KB, QD=32, 1 job | 5380 IOPS (2.82 GB/s) | > | Rand read, 512KB, QD=32, 4 jobs | 5206 IOPS (2.27 GB/s) | > | Rand write, 128KB, QD=32, 1 job | 9617 IOPS (1.26 GB/s) | > | Rand write, 128KB, QD=32, 4 jobs | 8405 IOPS (1.10 GB/s) | > +----------------------------------+------------------------+ > > These results use the default MDTS of the NVMe enpoint driver of 512 KB. > > This driver is not intended for production use but rather to be a > playground for learning NVMe and exploring/testing new NVMe features > while providing reasonably good performance. > Tested-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> - Mani -- மணிவண்ணன் சதாசிவம்
