On 2024/11/14 5:54, Terry Bowman wrote:
The CXL mem driver (cxl_mem) currently maps and caches a pointer to RAS
registers for the endpoint's root port. The same needs to be done for
each of the CXL downstream switch ports and CXL root ports found between
the endpoint and CXL host bridge.
Introduce cxl_init_ep_ports_aer() to be called for each port in the
sub-topology between the endpoint and the CXL host bridge. This function
will determine if there are CXL downstream switch ports or CXL root ports
associated with this port. The same check will be added in the future for
upstream switch ports.
Move the RAS register map logic from cxl_dport_map_ras() into
cxl_dport_init_ras_reporting(). This eliminates the need for the helper
function, cxl_dport_map_ras().
cxl_init_ep_ports_aer() calls cxl_dport_init_ras_reporting() to map
the RAS registers for CXL downstream switch ports and CXL root ports.
cxl_dport_init_ras_reporting() must check for previously mapped registers
before mapping. This is necessary because endpoints under a CXL switch
may share CXL downstream switch ports or CXL root ports. Ensure the port
registers are only mapped once.
Signed-off-by: Terry Bowman <terry.bowman@xxxxxxx>
[snip]
static int devm_cxl_add_endpoint(struct device *host, struct cxl_memdev *cxlmd,
struct cxl_dport *parent_dport)
{
@@ -62,6 +87,7 @@ static int devm_cxl_add_endpoint(struct device *host, struct cxl_memdev *cxlmd,
ep = cxl_ep_load(iter, cxlmd);
ep->next = down;
+ cxl_init_ep_ports_aer(ep);
In RCH case, seems like another issue is here, I believe that a RCD will
be added to a CXL root directly rather than a CXL host bridge, it means
that no chance to call cxl_init_ep_ports_aer() for a RCD, because this
loop is only for a EP attaching to a CXL non-root port.
Please correct me if I'm wrong.
Ming
}
/* Note: endpoint port component registers are derived from @cxlds */
@@ -166,8 +192,6 @@ static int cxl_mem_probe(struct device *dev)
else
endpoint_parent = &parent_port->dev;
- cxl_dport_init_ras_reporting(dport, dev);
-
scoped_guard(device, endpoint_parent) {
if (!endpoint_parent->driver) {
dev_err(dev, "CXL port topology %s not enabled\n",
