[PATCH 4/8] arm64: dts: qcom: x1e80100: Add support for PCIe3 on x1e80100

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Describe PCIe3 controller and PHY. Also add required system resources like
regulators, clocks, interrupts and registers configuration for PCIe3.

Signed-off-by: Qiang Yu <quic_qianyu@xxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/x1e80100.dtsi | 205 ++++++++++++++++++++++++-
 1 file changed, 204 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
index 74b694e74705..55b81e7de1c7 100644
--- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi
+++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
@@ -744,7 +744,7 @@ gcc: clock-controller@100000 {
 
 			clocks = <&bi_tcxo_div2>,
 				 <&sleep_clk>,
-				 <0>,
+				 <&pcie3_phy>,
 				 <&pcie4_phy>,
 				 <&pcie5_phy>,
 				 <&pcie6a_phy>,
@@ -2879,6 +2879,209 @@ mmss_noc: interconnect@1780000 {
 			#interconnect-cells = <2>;
 		};
 
+		pcie3: pci@1bd0000 {
+			device_type = "pci";
+			compatible = "qcom,pcie-x1e80100";
+			reg = <0 0x01bd0000 0 0x3000>,
+			      <0 0x78000000 0 0xf1d>,
+			      <0 0x78000f40 0 0xa8>,
+			      <0 0x78001000 0 0x1000>,
+			      <0 0x78100000 0 0x100000>;
+			reg-names = "parf",
+				    "dbi",
+				    "elbi",
+				    "atu",
+				    "config";
+			#address-cells = <3>;
+			#size-cells = <2>;
+			ranges = <0x01000000 0 0x00000000 0 0x78200000 0 0x100000>,
+				 <0x02000000 0 0x78300000 0 0x78300000 0 0x3d00000>;
+			bus-range = <0 0xff>;
+
+			dma-coherent;
+
+			linux,pci-domain = <3>;
+			num-lanes = <8>;
+
+			interrupts = <GIC_SPI 158 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 166 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 769 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 836 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 671 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 200 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 218 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 219 IRQ_TYPE_LEVEL_HIGH>;
+			interrupt-names = "msi0",
+					  "msi1",
+					  "msi2",
+					  "msi3",
+					  "msi4",
+					  "msi5",
+					  "msi6",
+					  "msi7";
+
+			#interrupt-cells = <1>;
+			interrupt-map-mask = <0 0 0 0x7>;
+			interrupt-map = <0 0 0 1 &intc 0 0 0 220 IRQ_TYPE_LEVEL_HIGH>,
+					<0 0 0 2 &intc 0 0 0 221 IRQ_TYPE_LEVEL_HIGH>,
+					<0 0 0 3 &intc 0 0 0 237 IRQ_TYPE_LEVEL_HIGH>,
+					<0 0 0 4 &intc 0 0 0 238 IRQ_TYPE_LEVEL_HIGH>;
+
+			clocks = <&gcc GCC_PCIE_3_PIPE_CLK_SRC>,
+				 <&gcc GCC_PCIE_3_AUX_CLK>,
+				 <&gcc GCC_PCIE_3_CFG_AHB_CLK>,
+				 <&gcc GCC_PCIE_3_MSTR_AXI_CLK>,
+				 <&gcc GCC_PCIE_3_SLV_AXI_CLK>,
+				 <&gcc GCC_PCIE_3_SLV_Q2A_AXI_CLK>,
+				 <&gcc GCC_CFG_NOC_PCIE_ANOC_SOUTH_AHB_CLK>,
+				 <&gcc GCC_CNOC_PCIE_NORTH_SF_AXI_CLK>;
+			clock-names = "pipe_clk_src",
+				      "aux",
+				      "cfg",
+				      "bus_master",
+				      "bus_slave",
+				      "slave_q2a",
+				      "noc_aggr",
+				      "cnoc_sf_axi";
+
+			assigned-clocks = <&gcc GCC_PCIE_3_AUX_CLK>;
+			assigned-clock-rates = <19200000>;
+
+			interconnects = <&pcie_south_anoc MASTER_PCIE_3 QCOM_ICC_TAG_ALWAYS
+					 &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
+					<&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS
+					 &cnoc_main SLAVE_PCIE_3 QCOM_ICC_TAG_ALWAYS>;
+			interconnect-names = "pcie-mem",
+					     "cpu-pcie";
+
+			resets = <&gcc GCC_PCIE_3_BCR>,
+				 <&gcc GCC_PCIE_3_LINK_DOWN_BCR>;
+			reset-names = "pci",
+				      "link_down";
+
+			power-domains = <&gcc GCC_PCIE_3_GDSC>;
+
+			phys = <&pcie3_phy>;
+			phy-names = "pciephy";
+
+			operating-points-v2 = <&pcie3_opp_table>;
+
+			status = "disabled";
+
+			pcie3_opp_table: opp-table {
+				compatible = "operating-points-v2";
+
+				/* GEN 1 x1 */
+				opp-2500000 {
+					opp-hz = /bits/ 64 <2500000>;
+					required-opps = <&rpmhpd_opp_low_svs>;
+					opp-peak-kBps = <250000 1>;
+				};
+
+				/* GEN 1 x2 and GEN 2 x1 */
+				opp-5000000 {
+					opp-hz = /bits/ 64 <5000000>;
+					required-opps = <&rpmhpd_opp_low_svs>;
+					opp-peak-kBps = <500000 1>;
+				};
+
+				/* GEN 1 x4 and GEN 2 x2*/
+				opp-10000000 {
+					opp-hz = /bits/ 64 <10000000>;
+					required-opps = <&rpmhpd_opp_low_svs>;
+					opp-peak-kBps = <1000000 1>;
+				};
+
+				/* GEN 1 x8 and GEN 2 X4 */
+				opp-20000000 {
+					opp-hz = /bits/ 64 <20000000>;
+					required-opps = <&rpmhpd_opp_low_svs>;
+					opp-peak-kBps = <2000000 1>;
+				};
+
+				/* GEN 2 x8 */
+				opp-40000000 {
+					opp-hz = /bits/ 64 <40000000>;
+					required-opps = <&rpmhpd_opp_low_svs>;
+					opp-peak-kBps = <4000000 1>;
+				};
+
+				/* GEN 3 x1 */
+				opp-8000000 {
+					opp-hz = /bits/ 64 <8000000>;
+					required-opps = <&rpmhpd_opp_svs>;
+					opp-peak-kBps = <984500 1>;
+				};
+
+				/* GEN 3 x2 and GEN 4 x1 */
+				opp-16000000 {
+					opp-hz = /bits/ 64 <16000000>;
+					required-opps = <&rpmhpd_opp_svs>;
+					opp-peak-kBps = <1969000 1>;
+				};
+
+				/* GEN 3 x4 and GEN 4 x2 */
+				opp-32000000 {
+					opp-hz = /bits/ 64 <32000000>;
+					required-opps = <&rpmhpd_opp_svs>;
+					opp-peak-kBps = <3938000 1>;
+				};
+
+				/* GEN 3 x8 and GEN 4 x4 */
+				opp-64000000 {
+					opp-hz = /bits/ 64 <64000000>;
+					required-opps = <&rpmhpd_opp_svs>;
+					opp-peak-kBps = <7876000 1>;
+				};
+
+				/* GEN 4 x8 */
+				opp-128000000 {
+					opp-hz = /bits/ 64 <128000000>;
+					required-opps = <&rpmhpd_opp_svs>;
+					opp-peak-kBps = <15753000 1>;
+				};
+			};
+		};
+
+		pcie3_phy: phy@1be0000 {
+			compatible = "qcom,x1e80100-qmp-gen4x8-pcie-phy";
+			reg = <0 0x01be0000 0 0x10000>;
+
+			clocks = <&gcc GCC_PCIE_3_AUX_CLK>,
+				 <&gcc GCC_PCIE_3_CFG_AHB_CLK>,
+				 <&rpmhcc RPMH_CXO_CLK>,
+				 <&gcc GCC_PCIE_3_PHY_RCHNG_CLK>,
+				 <&gcc GCC_PCIE_3_PHY_AUX_CLK>,
+				 <&gcc GCC_PCIE_3_PIPE_CLK>,
+				 <&gcc GCC_PCIE_3_PIPEDIV2_CLK>,
+				 <&tcsr TCSR_PCIE_8L_CLKREF_EN>;
+			clock-names = "aux",
+				      "cfg_ahb",
+				      "ref",
+				      "rchng",
+				      "phy_aux",
+				      "pipe",
+				      "pipediv2",
+				      "clkref_en";
+
+			resets = <&gcc GCC_PCIE_3_PHY_BCR>,
+				 <&gcc GCC_PCIE_3_NOCSR_COM_PHY_BCR>;
+			reset-names = "phy",
+				      "phy_nocsr";
+
+			assigned-clocks = <&gcc GCC_PCIE_3_PHY_RCHNG_CLK>;
+			assigned-clock-rates = <100000000>;
+
+			power-domains = <&gcc GCC_PCIE_3_PHY_GDSC>;
+
+			#clock-cells = <0>;
+			clock-output-names = "pcie3_pipe_clk";
+
+			#phy-cells = <0>;
+
+			status = "disabled";
+		};
+
 		pcie6a: pci@1bf8000 {
 			device_type = "pci";
 			compatible = "qcom,pcie-x1e80100";
-- 
2.34.1





[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux