[cc += Paul Luse, Jing Liu] On Wed, Jul 17, 2024 at 03:55:01PM -0500, Wei Huang wrote: > TPH (TLP Processing Hints) is a PCIe feature that allows endpoint devices to > provide optimization hints for requests that target memory space. These hints, > in a format called steering tag (ST), are provided in the requester's TLP > headers and allow the system hardware, including the Root Complex, to > optimize the utilization of platform resources for the requests. [...] > This series introduces generic TPH support in Linux, allowing STs to be > retrieved from ACPI _DSM (as defined by ACPI) and used by PCIe endpoint > drivers as needed. As a demonstration, it includes an example usage in the > Broadcom BNXT driver. When running on Broadcom NICs with the appropriate > firmware, Cache Injection shows substantial memory bandwidth savings and > better network bandwidth using real-world benchmarks. This solution is > vendor-neutral, as both TPH and ACPI _DSM are industry standards. I think you need to add support for saving and restoring TPH registers, otherwise the changes you make to those registers may not survive reset recovery or system sleep. Granted, system sleep may not be relevant for servers (which I assume you're targeting with your patches), but reset recovery very much is. Paul Luse submitted a patch two years ago to save and restore TPH registers, perhaps you can include it in your patch set? https://lore.kernel.org/all/20220712123641.2319-1-paul.e.luse@xxxxxxxxx/ Bjorn left some comments on Paul's patch: https://lore.kernel.org/all/20220912214516.GA538566@bhelgaas/ In particular, Bjorn asked for shared infrastructure to access TPH registers (which you're adding in your patch set) and spotted several nits (which should be easy to address). So I think you may be able to integrate Paul's patch into your series without too much effort. However note that when writing to TPH registers through the API you're introducing, you also need to update the saved register state so that those changes aren't lost upon a subsequent reset recovery. Thanks, Lukas
