On Wed, Jun 26, 2024 at 06:07:55PM +0530, Krishna chaitanya chundru wrote: > QPS615 switch needs to configured after powering on and before > PCIe link was up. s/need to configured/needs to be configured/ > As the PCIe controller driver already enables the PCIe link training > at the host side, stop the link training. Add blank line between paragraphs or rewrap into a single paragraph. > Otherwise the moment we turn on the switch it will participate in > the link training and link may come before switch is configured through > i2c. s/link may come before/link may come up before/ ? > The switch can be configured different ways like changing de-emphasis > settings of the switch, disabling unused ports etc and these settings > can vary from board to board, for that reason the sequence is taken > from the firmware file which contains the address of the slave, to address > and data to be written to the switch. The driver reads the firmware file > and parses them to apply those configurations to the switch. s/to address and data/the address and the data/ ? s/and parses them/and parses it/ (I assume you parse the file?)
