On Thu, 4 Jan 2024 at 15:03, Bartosz Golaszewski <brgl@xxxxxxxx> wrote:
>
> From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
>
> Describe the ath11k WLAN on-board the QCA6390 module. Include the
> relevant regulators and the enable GPIO.
>
> Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/qrb5165-rb5.dts | 24 ++++++++++++++++++++++++
> 1 file changed, 24 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
> index cd0db4f31d4a..721f86af952b 100644
> --- a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
> +++ b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
> @@ -734,6 +734,22 @@ &pcie0_phy {
> vdda-pll-supply = <&vreg_l9a_1p2>;
> };
>
> +&pcieport0 {
> + wifi@0 {
> + compatible = "pci17cb,1101";
> + reg = <0x10000 0x0 0x0 0x0 0x0>;
> +
> + pinctrl-names = "default";
> + pinctrl-0 = <&wlan_en_state>;
> +
> + enable-gpios = <&tlmm 20 GPIO_ACTIVE_HIGH>;
> +
> + vddpmu-supply = <&vreg_s2f_0p95>;
> + vddpcie1-supply = <&vreg_s8c_1p3>;
> + vddpcie2-supply = <&vreg_s5a_1p9>;
If I remember correctly, qca6390 has at least 8 power supplies AON,
PMU, 3xRFA, 2xPCIe and VDDIO.
Moreover, these bindings do not solve another problem: the PMU is
shared between WiFi and BT parts. For the next gen (WCN6855) this
becomes even more important, see the code in msm-5.10 which makes sure
that there is a proper time between one of the units going down and
another one being powered on.
> + };
> +};
> +
> &pcie1 {
> status = "okay";
> };
> @@ -1303,6 +1319,14 @@ sdc2_card_det_n: sd-card-det-n-state {
> function = "gpio";
> bias-pull-up;
> };
> +
> + wlan_en_state: wlan-default-state {
> + pins = "gpio20";
> + function = "gpio";
> + drive-strength = <16>;
> + output-low;
> + bias-pull-up;
> + };
> };
>
> &uart6 {
> --
> 2.40.1
>
>
--
With best wishes
Dmitry
