On Wed, Dec 06, 2023 at 10:36:56AM -0600, Bjorn Helgaas wrote:
> In subject, maybe you mean "Use 'linux,pci-domain' as slot ID"?
> "Using" is the wrong verb form here.
>
> On Wed, Dec 06, 2023 at 10:58:58AM -0500, Frank Li wrote:
> > Avoid use get slot id by compared with register physical address. If there
> > are more than 2 slots, compared logic will become complex.
>
> But this doesn't say anything about "linux,pci-domain", and I don't
> see anything about a register physical address in the patch.
>
> Maybe this commit log was meant for a different patch? I'm confused.
>
> > Signed-off-by: Frank Li <Frank.Li@xxxxxxx>
> > ---
> > drivers/pci/controller/dwc/pci-imx6.c | 6 ++++++
> > 1 file changed, 6 insertions(+)
> >
> > diff --git a/drivers/pci/controller/dwc/pci-imx6.c b/drivers/pci/controller/dwc/pci-imx6.c
> > index 62d77fabd82a..239ef439ba70 100644
> > --- a/drivers/pci/controller/dwc/pci-imx6.c
> > +++ b/drivers/pci/controller/dwc/pci-imx6.c
> > @@ -33,6 +33,7 @@
> > #include <linux/pm_domain.h>
> > #include <linux/pm_runtime.h>
> >
> > +#include "../../pci.h"
> > #include "pcie-designware.h"
> >
> > #define IMX8MQ_GPR_PCIE_REF_USE_PAD BIT(9)
> > @@ -1333,6 +1334,11 @@ static int imx6_pcie_probe(struct platform_device *pdev)
> > "Failed to get PCIEPHY reset control\n");
> > }
> >
> > + /* Using linux,pci-domain as PCI slot id */
> > + imx6_pcie->controller_id = of_get_pci_domain_nr(node);
> > + if (imx6_pcie->controller_id)
> > + imx6_pcie->controller_id = 0;
>
> I don't understand what this is doing. It looks the same as just:
Good capture. It should be
if (imx6_pcie->controller_id < 0)
imx6_pcie->controller_id = 0;
for only one PCI controller case. I just tested first one slot before send
patch, so not met problem.
Previously, we use below logic
if (dbi_base->start == IMX8MQ_PCIE2_BASE_ADDR)
imx6_pcie->controller_id = 1;
It is not good to depend on register's base address. If there are 3
controllers, check logic will becomoe ugly.
Frank
>
> imx6_pcie->controller_id = 0;
>
> Maybe this is a typo? As written, it doesn't look like there's any
> point in calling of_get_pci_domain_nr().
>
> > switch (imx6_pcie->drvdata->variant) {
> > case IMX7D:
> > if (dbi_base->start == IMX8MQ_PCIE2_BASE_ADDR)
> > --
> > 2.34.1
> >
