Re: [PATCH v21] PCI: Avoid D3 at suspend for AMD PCIe root ports w/ USB4 controllers

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 10/3/2023 13:31, Bjorn Helgaas wrote:
On Tue, Oct 03, 2023 at 01:06:48PM -0500, Mario Limonciello wrote:
On 10/3/2023 12:24, Bjorn Helgaas wrote:
On Mon, Oct 02, 2023 at 01:09:06PM -0500, Mario Limonciello wrote:
Iain reports that USB devices can't be used to wake a Lenovo Z13 from
suspend.  This occurs because on some AMD platforms, even though the Root
Ports advertise PME_Support for D3hot and D3cold, they don't handle PME
messages and generate wakeup interrupts from those states when amd-pmc has
put the platform in a hardware sleep state.
...

Two questions:

    - PME also doesn't work in D3hot, right?

Right.

IMO pci_d3cold_*() is poorly named.
It's going to prevent D3 on the bridge.

I agree, that name is super irritating.  I don't even know how to
figure out or verify that pci_d3cold_disable() also disables D3hot.

    - Is it OK to use D3hot and D3cold if we don't have a wakeup device
      below the Root Port?  I assume that scenario is possible?

Yes; it's "fine to do that" if there is no wakeup device below the
root port.

If a user intentionally turns off power/wakeup for the child devices
(which as said before was USB4 and XHCI PCIe devices) then wakeup
won't be set.

So in this case as the quirk is implemented I expect the root port
will be left in D0 even if a user intentionally turns off
power/wakeup for the USB4 and XHCI devices.

Even if users don't intentionally turn off wakeup, there are devices
like mass storage and NICs without wake-on-LAN that don't require
wakeup.

I assume that if there's no downstream device that needs wakeup, this
quirk means we will keep the Root Port in D0 even though we could
safely put it in D3hot or D3cold.

Yes that matches my expectation as well.


That's one thing I liked about the v20 iteration -- instead of
pci_d3cold_disable(), we changed dev->pme_support, which should mean
that we only avoid D3hot/D3cold if we need PMEs while in those states,
so I assumed that we *could* use D3 when we don't need the wakeups.

Bjorn

If you think it's worth spinning again for this optimization I think a device_may_wakeup() check on the root port can achieve the same result as the v20 PME solution did, but without the walking of a tree in the quirk.



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux