[+cc Rafael] On Fri, May 12, 2023 at 08:00:13AM +0800, Kai-Heng Feng wrote: > PCIe services that share an IRQ with PME, such as AER or DPC, may cause a > spurious wakeup on system suspend. To prevent this, disable the AER interrupt > notification during the system suspend process. I see that in this particular BZ dmesg log, PME, AER, and DPC do share the same IRQ, but I don't think this is true in general. Root Ports usually use MSI or MSI-X. PME and hotplug events use the Interrupt Message Number in the PCIe Capability, but AER uses the one in the AER Root Error Status register, and DPC uses the one in the DPC Capability register. Those potentially correspond to three distinct MSI/MSI-X vectors. I think this probably has nothing to do with the IRQ being *shared*, but just that putting the downstream component into D3cold, where the link state is L3, may cause the upstream component to log and signal a link-related error as the link goes completely down. I don't think D0-D3hot should be relevant here because in all those states, the link should be active because the downstream config space remains accessible. So I'm not sure if it's possible, but I wonder if there's a more targeted place we could do this, e.g., in the path that puts downstream devices in D3cold. > As Per PCIe Base Spec 5.0, section 5.2, titled "Link State Power Management", > TLP and DLLP transmission are disabled for a Link in L2/L3 Ready (D3hot), L2 > (D3cold with aux power) and L3 (D3cold) states. So disabling the AER > notification during suspend and re-enabling them during the resume process > should not affect the basic functionality. > > Link: https://bugzilla.kernel.org/show_bug.cgi?id=216295 > Reviewed-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx> > Signed-off-by: Kai-Heng Feng <kai.heng.feng@xxxxxxxxxxxxx> > --- > v6: > v5: > - Wording. > > v4: > v3: > - No change. > > v2: > - Only disable AER IRQ. > - No more check on PME IRQ#. > - Use helper. > > drivers/pci/pcie/aer.c | 22 ++++++++++++++++++++++ > 1 file changed, 22 insertions(+) > > diff --git a/drivers/pci/pcie/aer.c b/drivers/pci/pcie/aer.c > index 1420e1f27105..9c07fdbeb52d 100644 > --- a/drivers/pci/pcie/aer.c > +++ b/drivers/pci/pcie/aer.c > @@ -1356,6 +1356,26 @@ static int aer_probe(struct pcie_device *dev) > return 0; > } > > +static int aer_suspend(struct pcie_device *dev) > +{ > + struct aer_rpc *rpc = get_service_data(dev); > + struct pci_dev *pdev = rpc->rpd; > + > + aer_disable_irq(pdev); > + > + return 0; > +} > + > +static int aer_resume(struct pcie_device *dev) > +{ > + struct aer_rpc *rpc = get_service_data(dev); > + struct pci_dev *pdev = rpc->rpd; > + > + aer_enable_irq(pdev); > + > + return 0; > +} > + > /** > * aer_root_reset - reset Root Port hierarchy, RCEC, or RCiEP > * @dev: pointer to Root Port, RCEC, or RCiEP > @@ -1420,6 +1440,8 @@ static struct pcie_port_service_driver aerdriver = { > .service = PCIE_PORT_SERVICE_AER, > > .probe = aer_probe, > + .suspend = aer_suspend, > + .resume = aer_resume, > .remove = aer_remove, > }; > > -- > 2.34.1 >
