On Thu, Jul 06, 2023 at 08:39:54AM +0200, Krzysztof Kozlowski wrote: > On 05/07/2023 10:46, Manivannan Sadhasivam wrote: > > On Wed, Jul 05, 2023 at 01:47:05PM +0530, Mrinmay Sarkar wrote: > >> Update the relavent DT bindings for PCIe, add new config to the phy > >> driver add pcie and phy nodes to the .dtsi file and enable then in > >> board .dts file for the sa8775p-ride platform. > >> > >> Mrinmay Sarkar (6): > >> dt-bindings: PCI: qcom: Add sa8775p compatible > >> dt-bindings: phy: qcom,qmp: Add sa8775p QMP PCIe PHY > >> PCI: qcom: Add support for sa8775p SoC > >> phy: qcom-qmp-pcie: add support for sa8775p > >> arm64: dts: qcom: sa8775p: Add pcie0 and pcie1 nodes > >> arm64: dts: qcom: sa8775p-ride: enable pcie nodes > > > > Please note that the dts patches should come before driver patches. > > > > Why? DTS is always independent thus usually put at the end of patchset > or better separate. It is the first time I hear that DTS should be > before driver. > This is what I was suggested by Rob during my initial days and I've been following this pattern since then. If that's not the case, I have no issues. - Mani > Best regards, > Krzysztof > -- மணிவண்ணன் சதாசிவம்
