During long periods of the PCIe RC HW being in an L1SS sleep state, there
may be a timeout on an internal bus access, even though there may not be
any PCIe access involved. Such a timeout will cause a subsequent CPU
abort.
So, when "brcm,enable-l1ss" is observed, we increase the timeout value to
four seconds instead of using its HW default.
Tested-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
Signed-off-by: Jim Quinlan <jim2101024@xxxxxxxxx>
---
drivers/pci/controller/pcie-brcmstb.c | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index d30636a725d7..fe0415a98c63 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -1034,6 +1034,21 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie)
return 0;
}
+/*
+ * This extends the timeout period for an access to an internal bus. This
+ * access timeout may occur during L1SS sleep periods even without the
+ * presence of a PCIe access.
+ */
+static void brcm_extend_rbus_timeout(struct brcm_pcie *pcie)
+{
+ /* TIMEOUT register is two registers before RGR1_SW_INIT_1 */
+ const unsigned int REG_OFFSET = PCIE_RGR1_SW_INIT_1(pcie) - 8;
+ u32 timeout_us = 4000000; /* 4 seconds, our setting for L1SS */
+
+ /* Each unit in timeout register is 1/216,000,000 seconds */
+ writel(216 * timeout_us, pcie->base + REG_OFFSET);
+}
+
static void brcm_config_clkreq(struct brcm_pcie *pcie)
{
bool l1ss = of_property_read_bool(pcie->np, "brcm,enable-l1ss");
@@ -1059,6 +1074,7 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie)
* of 400ns, as specified in 3.2.5.2.2 of the PCI Express
* Mini CEM 2.0 specification.
*/
+ brcm_extend_rbus_timeout(pcie);
clkreq_set |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK;
dev_info(pcie->dev, "bi-dir CLKREQ# for L1SS power savings");
} else {
--
2.17.1
