On Fri, Mar 31, 2023 at 03:31:40PM -0700, Ben Greear wrote:
> On 3/31/23 15:06, Bjorn Helgaas wrote:
> > [+cc iwlwifi folks]
> >
> > Re: 8795e182b02d ("PCI/portdrv: Don't disable AER reporting in
> > get_port_device_capability()")
> >
> > On Wed, Mar 29, 2023 at 04:17:29PM -0700, Ben Greear wrote:
> > > On 8/30/22 3:16 PM, Ben Greear wrote:
> > > ...
> >
> > > I notice this patch appears to be in 6.2.6 kernel, and my kernel logs are
> > > full of spam and system is unstable. Possibly the unstable part is related
> > > to something else, but the log spam is definitely extreme.
> > >
> > > These systems are fairly stable on 5.19-ish kernels without the patch in
> > > question.
> >
> > Hmmm, I was going to thank you for the report, but looking closer, I
> > see that you reported this last August [1] and we *should* have
> > pursued it with the iwlwifi folks or figured out what the PCI core is
> > doing wrong, but I totally dropped the ball. Sorry about that.
> >
> > To make sure we're all on the same page, we're talking about
> > 8795e182b02d ("PCI/portdrv: Don't disable AER reporting in
> > get_port_device_capability()") [2],
> > which is present in v6.0 and later [3] but not v5.19.16 [4].
>
> Yes, though I manually tried reverting that patch, and problem
> persisted, so maybe some secondary patch still enables whatever
> causes the issue.
>
> Booting with pci=noaer 'fixes' the problem for me, that is what I am
> running currently.
>
> > > Here is sample of the spam:
> > >
> > > [ 1675.547023] pcieport 0000:03:02.0: PCIe Bus Error: severity=Uncorrected (Non-Fatal), type=Transaction Layer, (Requester ID)
> > > [ 1675.556851] pcieport 0000:03:02.0: device [10b5:8619] error status/mask=00100000/00000000
> > > [ 1675.563904] pcieport 0000:03:02.0: [20] UnsupReq (First)
> > > [ 1675.569398] pcieport 0000:03:02.0: AER: TLP Header: 34000000 05001f10 00000000 88c888c8
> > > [ 1675.576296] iwlwifi 0000:05:00.0: AER: can't recover (no error_detected callback)
> >
> > The TLP header says this is an LTR message from 05:00.0. Apparently
> > the bridge above 05:00.0 is 03:02.0, which logged an Unsupported
> > Request error for the message, probably because 03:02.0 doesn't have
> > LTR enabled.
> Here is lspci, and please note that I am using a pcie -> 12x m.2
> adapter board, which is not common in the world. Possibly it is
> causing some of the problems with the AER logic (though, it is
> stable in 5.19 and lower. And a similar system with 2 of these
> adapter boards filled with 24 mtk7922 radios does not show the AER
> warnings or instability problems so far.)
>
> The lspci below is from a system with 12 ax210 radios, I have
> another with 24, it shows similar problems.
Interesting config. Somebody is definitely doing something wrong.
LTR is enabled at 00:1c.0 (which is fine), not supported and disabled
at 02:00.0 and 03:02.0 (also fine), but *enabled* at 05:00.0, which is
absolutely not fine because 03:02.0 won't know what to do with the LTR
messages and would log the AER errors you're seeing.
> 00:1c.0 PCI bridge: Intel Corporation 100 Series/C230 Series Chipset Family PCI Express Root Port #1 (rev f1) (prog-if 00 [Normal decode])
> Bus: primary=00, secondary=02, subordinate=0f, sec-latency=0
> DevCap2: Completion Timeout: Range ABC, TimeoutDis+, LTR+, OBFF Not Supported ARIFwd+
> AtomicOpsCap: Routing- 32bit- 64bit- 128bitCAS-
> DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR+, OBFF Disabled ARIFwd-
> 02:00.0 PCI bridge: PLX Technology, Inc. PEX 8619 16-lane, 16-Port PCI Express Gen 2 (5.0 GT/s) Switch with DMA (rev ba) (prog-if 00 [Normal decode])
> Bus: primary=02, secondary=03, subordinate=0f, sec-latency=0
> DevCap2: Completion Timeout: Not Supported, TimeoutDis-, LTR-, OBFF Not Supported
> AtomicOpsCap: Routing- 32bit- 64bit- 128bitCAS-
> DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, OBFF Disabled
> 03:02.0 PCI bridge: PLX Technology, Inc. PEX 8619 16-lane, 16-Port PCI Express Gen 2 (5.0 GT/s) Switch with DMA (rev ba) (prog-if 00 [Normal decode])
> Bus: primary=03, secondary=05, subordinate=05, sec-latency=0
> DevCap2: Completion Timeout: Not Supported, TimeoutDis-, LTR-, OBFF Not Supported ARIFwd+
> AtomicOpsCap: Routing-
> DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, OBFF Disabled ARIFwd-
> 05:00.0 Network controller: Intel Corporation Device 2725 (rev 1a)
> DevCap2: Completion Timeout: Range B, TimeoutDis+, LTR+, OBFF Via WAKE#
> AtomicOpsCap: 32bit- 64bit- 128bitCAS-
> DevCtl2: Completion Timeout: 16ms to 55ms, TimeoutDis-, LTR+, OBFF Disabled
> AtomicOpsCtl: ReqEn-
For 02:00.0 and 03:02.0, pci_configure_ltr() should bail out as soon
as it sees they don't support PCI_EXP_DEVCAP2_LTR, so they should
never have dev->ltr_path set. And pci_configure_ltr() should not set
PCI_EXP_DEVCTL2_LTR_EN for 05:00.0 since bridge->ltr_path is not set
for 03:02.0.
Can you collect the dmesg log when booted with "pci=earlydump"? I
wonder if BIOS could be enabling LTR on 05:00.0.
Bjorn
