Add PCIe controllers and PHY nodes. Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx> --- This patch does not have a v3, but since it is now part of the same patchset with the controller and the phy drivers patches, I had to bump the version to 4. The v4 was here: https://lore.kernel.org/all/20230119140453.3942340-12-abel.vesa@xxxxxxxxxx/ Changes since v4: * renamed noc_aggr_4 back to noc_aggr * moved pinctrl properties out to MTP dts * renamed nocsr to nocsr_com Changes since v2: * renamed the pcie_1_link_down_reset to simply link_down * dropped the pipe from clock-names * renamed aggre clock-names to noc_aggr_4 * dropped the _pcie infix from cnoc_pcie_sf_axi * dropped the aux_phy clock from the pcie1 Changes since v1: * ordered pcie related nodes alphabetically in MTP dts * dropped the pipe_mux, phy_pipe and ref clocks from the pcie nodes * dropped the child node from the phy nodes, like Johan suggested, and updated to use the sc8280xp binding scheme * changed "pcie_1_nocsr_com_phy_reset" 2nd reset name of pcie1_phy to "nocsr" * reordered all pcie nodes properties to look similar to the ones from sc8280xp arch/arm64/boot/dts/qcom/sm8550.dtsi | 203 ++++++++++++++++++++++++++- 1 file changed, 200 insertions(+), 3 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/sm8550.dtsi b/arch/arm64/boot/dts/qcom/sm8550.dtsi index 3d47281a276b..4daf1f03d79f 100644 --- a/arch/arm64/boot/dts/qcom/sm8550.dtsi +++ b/arch/arm64/boot/dts/qcom/sm8550.dtsi @@ -646,9 +646,9 @@ gcc: clock-controller@100000 { #reset-cells = <1>; #power-domain-cells = <1>; clocks = <&bi_tcxo_div2>, <&sleep_clk>, - <0>, - <0>, - <0>, + <&pcie0_phy>, + <&pcie1_phy>, + <&pcie_1_phy_aux_clk>, <&ufs_mem_phy 0>, <&ufs_mem_phy 1>, <&ufs_mem_phy 2>, @@ -1547,6 +1547,203 @@ mmss_noc: interconnect@1780000 { qcom,bcm-voters = <&apps_bcm_voter>; }; + pcie0: pci@1c00000 { + device_type = "pci"; + compatible = "qcom,pcie-sm8550"; + reg = <0 0x01c00000 0 0x3000>, + <0 0x60000000 0 0xf1d>, + <0 0x60000f20 0 0xa8>, + <0 0x60001000 0 0x1000>, + <0 0x60100000 0 0x100000>; + reg-names = "parf", "dbi", "elbi", "atu", "config"; + #address-cells = <3>; + #size-cells = <2>; + ranges = <0x01000000 0x0 0x60200000 0 0x60200000 0x0 0x100000>, + <0x02000000 0x0 0x60300000 0 0x60300000 0x0 0x3d00000>; + bus-range = <0x00 0xff>; + + dma-coherent; + + linux,pci-domain = <0>; + num-lanes = <2>; + + interrupts = <GIC_SPI 141 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "msi"; + + #interrupt-cells = <1>; + interrupt-map-mask = <0 0 0 0x7>; + interrupt-map = <0 0 0 1 &intc 0 0 0 149 IRQ_TYPE_LEVEL_HIGH>, /* int_a */ + <0 0 0 2 &intc 0 0 0 150 IRQ_TYPE_LEVEL_HIGH>, /* int_b */ + <0 0 0 3 &intc 0 0 0 151 IRQ_TYPE_LEVEL_HIGH>, /* int_c */ + <0 0 0 4 &intc 0 0 0 152 IRQ_TYPE_LEVEL_HIGH>; /* int_d */ + + clocks = <&gcc GCC_PCIE_0_AUX_CLK>, + <&gcc GCC_PCIE_0_CFG_AHB_CLK>, + <&gcc GCC_PCIE_0_MSTR_AXI_CLK>, + <&gcc GCC_PCIE_0_SLV_AXI_CLK>, + <&gcc GCC_PCIE_0_SLV_Q2A_AXI_CLK>, + <&gcc GCC_DDRSS_PCIE_SF_QTB_CLK>, + <&gcc GCC_AGGRE_NOC_PCIE_AXI_CLK>; + clock-names = "aux", + "cfg", + "bus_master", + "bus_slave", + "slave_q2a", + "ddrss_sf_tbu", + "noc_aggr"; + + interconnects = <&pcie_noc MASTER_PCIE_0 0 &mc_virt SLAVE_EBI1 0>, + <&gem_noc MASTER_APPSS_PROC 0 &cnoc_main SLAVE_PCIE_0 0>; + interconnect-names = "pcie-mem", "cpu-pcie"; + + iommus = <&apps_smmu 0x1400 0x7f>; + iommu-map = <0x0 &apps_smmu 0x1400 0x1>, + <0x100 &apps_smmu 0x1401 0x1>; + + resets = <&gcc GCC_PCIE_0_BCR>; + reset-names = "pci"; + + power-domains = <&gcc PCIE_0_GDSC>; + + phys = <&pcie0_phy>; + phy-names = "pciephy"; + + perst-gpios = <&tlmm 94 GPIO_ACTIVE_LOW>; + wake-gpios = <&tlmm 96 GPIO_ACTIVE_HIGH>; + + status = "disabled"; + }; + + pcie0_phy: phy@1c06000 { + compatible = "qcom,sm8550-qmp-gen3x2-pcie-phy"; + reg = <0 0x01c06000 0 0x2000>; + + clocks = <&gcc GCC_PCIE_0_AUX_CLK>, + <&gcc GCC_PCIE_0_CFG_AHB_CLK>, + <&tcsr TCSR_PCIE_0_CLKREF_EN>, + <&gcc GCC_PCIE_0_PHY_RCHNG_CLK>, + <&gcc GCC_PCIE_0_PIPE_CLK>; + clock-names = "aux", "cfg_ahb", "ref", "rchng", + "pipe"; + + resets = <&gcc GCC_PCIE_0_PHY_BCR>; + reset-names = "phy"; + + assigned-clocks = <&gcc GCC_PCIE_0_PHY_RCHNG_CLK>; + assigned-clock-rates = <100000000>; + + power-domains = <&gcc PCIE_0_PHY_GDSC>; + + #clock-cells = <0>; + clock-output-names = "pcie0_pipe_clk"; + + #phy-cells = <0>; + + status = "disabled"; + }; + + pcie1: pci@1c08000 { + device_type = "pci"; + compatible = "qcom,pcie-sm8550"; + reg = <0x0 0x01c08000 0x0 0x3000>, + <0x0 0x40000000 0x0 0xf1d>, + <0x0 0x40000f20 0x0 0xa8>, + <0x0 0x40001000 0x0 0x1000>, + <0x0 0x40100000 0x0 0x100000>; + reg-names = "parf", "dbi", "elbi", "atu", "config"; + #address-cells = <3>; + #size-cells = <2>; + ranges = <0x01000000 0x0 0x40200000 0 0x40200000 0x0 0x100000>, + <0x02000000 0x0 0x40300000 0 0x40300000 0x0 0x1fd00000>; + bus-range = <0x00 0xff>; + + dma-coherent; + + linux,pci-domain = <1>; + num-lanes = <2>; + + interrupts = <GIC_SPI 307 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "msi"; + + #interrupt-cells = <1>; + interrupt-map-mask = <0 0 0 0x7>; + interrupt-map = <0 0 0 1 &intc 0 0 0 434 IRQ_TYPE_LEVEL_HIGH>, /* int_a */ + <0 0 0 2 &intc 0 0 0 435 IRQ_TYPE_LEVEL_HIGH>, /* int_b */ + <0 0 0 3 &intc 0 0 0 438 IRQ_TYPE_LEVEL_HIGH>, /* int_c */ + <0 0 0 4 &intc 0 0 0 439 IRQ_TYPE_LEVEL_HIGH>; /* int_d */ + + clocks = <&gcc GCC_PCIE_1_AUX_CLK>, + <&gcc GCC_PCIE_1_CFG_AHB_CLK>, + <&gcc GCC_PCIE_1_MSTR_AXI_CLK>, + <&gcc GCC_PCIE_1_SLV_AXI_CLK>, + <&gcc GCC_PCIE_1_SLV_Q2A_AXI_CLK>, + <&gcc GCC_DDRSS_PCIE_SF_QTB_CLK>, + <&gcc GCC_AGGRE_NOC_PCIE_AXI_CLK>, + <&gcc GCC_CNOC_PCIE_SF_AXI_CLK>; + clock-names = "aux", + "cfg", + "bus_master", + "bus_slave", + "slave_q2a", + "ddrss_sf_tbu", + "noc_aggr", + "cnoc_sf_axi"; + + assigned-clocks = <&gcc GCC_PCIE_1_AUX_CLK>; + assigned-clock-rates = <19200000>; + + interconnects = <&pcie_noc MASTER_PCIE_1 0 &mc_virt SLAVE_EBI1 0>, + <&gem_noc MASTER_APPSS_PROC 0 &cnoc_main SLAVE_PCIE_1 0>; + interconnect-names = "pcie-mem", "cpu-pcie"; + + iommus = <&apps_smmu 0x1480 0x7f>; + iommu-map = <0x0 &apps_smmu 0x1480 0x1>, + <0x100 &apps_smmu 0x1481 0x1>; + + resets = <&gcc GCC_PCIE_1_BCR>, + <&gcc GCC_PCIE_1_LINK_DOWN_BCR>; + reset-names = "pci", "link_down"; + + power-domains = <&gcc PCIE_1_GDSC>; + + phys = <&pcie1_phy>; + phy-names = "pciephy"; + + perst-gpios = <&tlmm 97 GPIO_ACTIVE_LOW>; + enable-gpios = <&tlmm 99 GPIO_ACTIVE_HIGH>; + + status = "disabled"; + }; + + pcie1_phy: phy@1c0e000 { + compatible = "qcom,sm8550-qmp-gen4x2-pcie-phy"; + reg = <0x0 0x01c0e000 0x0 0x2000>; + + clocks = <&gcc GCC_PCIE_1_PHY_AUX_CLK>, + <&gcc GCC_PCIE_1_CFG_AHB_CLK>, + <&tcsr TCSR_PCIE_1_CLKREF_EN>, + <&gcc GCC_PCIE_1_PHY_RCHNG_CLK>, + <&gcc GCC_PCIE_1_PIPE_CLK>; + clock-names = "aux", "cfg_ahb", "ref", "rchng", + "pipe"; + + resets = <&gcc GCC_PCIE_1_PHY_BCR>, + <&gcc GCC_PCIE_1_NOCSR_COM_PHY_BCR>; + reset-names = "phy", "nocsr_com"; + + assigned-clocks = <&gcc GCC_PCIE_1_PHY_RCHNG_CLK>; + assigned-clock-rates = <100000000>; + + power-domains = <&gcc PCIE_1_PHY_GDSC>; + + #clock-cells = <0>; + clock-output-names = "pcie1_pipe_clk"; + + #phy-cells = <0>; + + status = "disabled"; + }; + cryptobam: dma-controller@1dc4000 { compatible = "qcom,bam-v1.7.0"; reg = <0x0 0x01dc4000 0x0 0x28000>; -- 2.34.1
