PING? On Wednesday 06 July 2022 12:10:43 Pali Rohár wrote: > By default old pre-3.0 Freescale PCIe controllers reports invalid PCI Class > Code 0x0b20 for PCIe Root Port. It can be seen by lspci -b output on P2020 > board which has this pre-3.0 controller: > > $ lspci -bvnn > 00:00.0 Power PC [0b20]: Freescale Semiconductor Inc P2020E [1957:0070] (rev 21) > !!! Invalid class 0b20 for header type 01 > Capabilities: [4c] Express Root Port (Slot-), MSI 00 > > Fix this issue by programming correct PCI Class Code 0x0604 for PCIe Root > Port to the Freescale specific PCIe register 0x474. > > With this change lspci -b output is: > > $ lspci -bvnn > 00:00.0 PCI bridge [0604]: Freescale Semiconductor Inc P2020E [1957:0070] (rev 21) (prog-if 00 [Normal decode]) > Capabilities: [4c] Express Root Port (Slot-), MSI 00 > > Without any "Invalid class" error. So class code was properly reflected > into standard (read-only) PCI register 0x08. > > Same fix is already implemented in U-Boot pcie_fsl.c driver in commit: > http://source.denx.de/u-boot/u-boot/-/commit/d18d06ac35229345a0af80977a408cfbe1d1015b > > Fix activated by U-Boot stay active also after booting Linux kernel. > But boards which use older U-Boot version without that fix are affected and > still require this fix. > > So implement this class code fix also in kernel fsl_pci.c driver. > > Cc: stable@xxxxxxxxxxxxxxx > Signed-off-by: Pali Rohár <pali@xxxxxxxxxx> > --- > arch/powerpc/sysdev/fsl_pci.c | 8 ++++++++ > arch/powerpc/sysdev/fsl_pci.h | 1 + > 2 files changed, 9 insertions(+) > > diff --git a/arch/powerpc/sysdev/fsl_pci.c b/arch/powerpc/sysdev/fsl_pci.c > index 1011cfea2e32..bfbb8c8fc9aa 100644 > --- a/arch/powerpc/sysdev/fsl_pci.c > +++ b/arch/powerpc/sysdev/fsl_pci.c > @@ -521,6 +521,7 @@ int fsl_add_bridge(struct platform_device *pdev, int is_primary) > struct resource rsrc; > const int *bus_range; > u8 hdr_type, progif; > + u32 class_code; > struct device_node *dev; > struct ccsr_pci __iomem *pci; > u16 temp; > @@ -594,6 +595,13 @@ int fsl_add_bridge(struct platform_device *pdev, int is_primary) > PPC_INDIRECT_TYPE_SURPRESS_PRIMARY_BUS; > if (fsl_pcie_check_link(hose)) > hose->indirect_type |= PPC_INDIRECT_TYPE_NO_PCIE_LINK; > + /* Fix Class Code to PCI_CLASS_BRIDGE_PCI_NORMAL for pre-3.0 controller */ > + if (in_be32(&pci->block_rev1) < PCIE_IP_REV_3_0) { > + early_read_config_dword(hose, 0, 0, PCIE_FSL_CSR_CLASSCODE, &class_code); > + class_code &= 0xff; > + class_code |= PCI_CLASS_BRIDGE_PCI_NORMAL << 8; > + early_write_config_dword(hose, 0, 0, PCIE_FSL_CSR_CLASSCODE, class_code); > + } > } else { > /* > * Set PBFR(PCI Bus Function Register)[10] = 1 to > diff --git a/arch/powerpc/sysdev/fsl_pci.h b/arch/powerpc/sysdev/fsl_pci.h > index cdbde2e0c96e..093a875d7d1e 100644 > --- a/arch/powerpc/sysdev/fsl_pci.h > +++ b/arch/powerpc/sysdev/fsl_pci.h > @@ -18,6 +18,7 @@ struct platform_device; > > #define PCIE_LTSSM 0x0404 /* PCIE Link Training and Status */ > #define PCIE_LTSSM_L0 0x16 /* L0 state */ > +#define PCIE_FSL_CSR_CLASSCODE 0x474 /* FSL GPEX CSR */ > #define PCIE_IP_REV_2_2 0x02080202 /* PCIE IP block version Rev2.2 */ > #define PCIE_IP_REV_3_0 0x02080300 /* PCIE IP block version Rev3.0 */ > #define PIWAR_EN 0x80000000 /* Enable */ > -- > 2.20.1 >
