On Wed, 13 Jul 2022 09:40:01 +0100 Martin Habets wrote: > > So it's switching between ethernet and vdpa? Isn't there a general > > problem for configuring vdpa capabilities (net vs storage etc) and > > shouldn't we seek to solve your BAR format switch in a similar fashion > > rather than adding PCI device attrs, which I believe is not done for > > anything vDPA-related? > > The initial support will be for vdpa net. vdpa block and RDMA will follow > later, and we also need to consider FPGA management. > > When it comes to vDPA there is a "vdpa" tool that we intend to support. > This comes into play after we've switched a device into vdpa mode (using > this new file). > For a network device there is also "devlink" to consider. That could be used > to switch a device into vdpa mode, but it cannot be used to switch it > back (there is no netdev to operate on). > My current understanding is that we won't have this issue for RDMA. > For FPGA management there is no general configuration tool, just what > fpga_mgr exposes (drivers/fpga). We intend to remove the special PF > devices we have for this (PCI space is valuable), and use the normal > network device in stead. I can give more details on this if you want. > Worst case a special BAR config would be needed for this, but if needed I > expect we can restrict this to the NIC provisioning stage. > > So there is a general problem I think. The solution here is something at > lower level, which is PCI in this case. > Another solution would be a proprietary tool, something we are off course > keen to avoid. Okay. Indeed, we could easily bolt something onto devlink, I'd think but I don't know the space enough to push for one solution over another. Please try to document the problem and the solution... somewhere, tho. Otherwise the chances that the next vendor with this problem follows the same approach fall from low to none.
