On Tue, May 17, 2022 at 12:37:38PM +0800, Kai-Heng Feng wrote: > We are seeing Master Abort bit is set on Intel I350 ethernet device and its > root port right after boot, probably happened during BIOS phase: > > 00:06.0 PCI bridge [0604]: Intel Corporation Device [8086:464d] (rev 05) (prog-if 00 [Normal decode]) > Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ > Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort+ >SERR- <PERR- INTx- > > 6e:00.0 Ethernet controller [0200]: Intel Corporation I350 Gigabit Network Connection [8086:1521] (rev 01) > Subsystem: Intel Corporation Ethernet Server Adapter I350-T2 [8086:00a2] > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ > Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort+ >SERR- <PERR- INTx- > > 6e:00.1 Ethernet controller [0200]: Intel Corporation I350 Gigabit Network Connection [8086:1521] (rev 01) > Subsystem: Intel Corporation Ethernet Server Adapter I350-T2 [8086:00a2] > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ > Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort+ >SERR- <PERR- INTx- > > And the Master Abort bit is cleared after S3. > > Since there's no functional impact found, clear the PCI_STATUS to treat > it anew at setting up. > > Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=215989 > Signed-off-by: Kai-Heng Feng <kai.heng.feng@xxxxxxxxxxxxx> Applied to pci/err for v5.20, thanks! > --- > drivers/pci/probe.c | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c > index 17a969942d370..414f659dc8735 100644 > --- a/drivers/pci/probe.c > +++ b/drivers/pci/probe.c > @@ -1890,6 +1890,9 @@ int pci_setup_device(struct pci_dev *dev) > > dev->broken_intx_masking = pci_intx_mask_broken(dev); > > + /* Clear errors left from system firmware */ > + pci_write_config_word(dev, PCI_STATUS, 0xffff); > + > switch (dev->hdr_type) { /* header type */ > case PCI_HEADER_TYPE_NORMAL: /* standard header */ > if (class == PCI_CLASS_BRIDGE_PCI) > -- > 2.34.1 >
