Re: [PATCH v11 1/5] clk: qcom: regmap: add PHY clock source implementation

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Jun 08, 2022 at 01:52:34PM +0300, Dmitry Baryshkov wrote:
> On recent Qualcomm platforms the QMP PIPE clocks feed into a set of
> muxes which must be parked to the "safe" source (bi_tcxo) when
> corresponding GDSC is turned off and on again. Currently this is
> handcoded in the PCIe driver by reparenting the gcc_pipe_N_clk_src
> clock. However the same code sequence should be applied in the
> pcie-qcom endpoint, USB3 and UFS drivers.
> 
> Rather than copying this sequence over and over again, follow the
> example of clk_rcg2_shared_ops and implement this parking in the
> enable() and disable() clock operations. Supplement the regmap-mux with
> the new clk_regmap_phy_mux type, which implements such multiplexers
> as a simple gate clocks.
> 
> This is possible since each of these multiplexers has just two clock
> sources: one coming from the PHY and a reference (XO) one.  If the clock
> is running off the from-PHY source, report it as enabled. Report it as
> disabled otherwise (if it uses reference source).
> 
> This way the PHY will disable the pipe clock before turning off the
> GDSC, which in turn would lead to disabling corresponding pipe_clk_src
> (and thus it being parked to a safe, reference clock source). And vice
> versa, after enabling the GDSC the PHY will enable the pipe clock, which
> would cause pipe_clk_src to be switched from a safe source to the
> working one.
> 
> Reviewed-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
> Tested-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
> Reported-by: kernel test robot <lkp@xxxxxxxxx>
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> ---
>  drivers/clk/qcom/Makefile             |  1 +
>  drivers/clk/qcom/clk-regmap-phy-mux.c | 62 +++++++++++++++++++++++++++
>  drivers/clk/qcom/clk-regmap-phy-mux.h | 33 ++++++++++++++
>  3 files changed, 96 insertions(+)
>  create mode 100644 drivers/clk/qcom/clk-regmap-phy-mux.c
>  create mode 100644 drivers/clk/qcom/clk-regmap-phy-mux.h

Since it's posted as part of the series, I assume this should all be
applied together, so I'll look for an ack from Bjorn Andersson
<bjorn.andersson@xxxxxxxxxx>, maintainer of drivers/clk/qcom.



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux