Add support for Tegra234 PCIe controllers. These controllers are based
on Synopsys DesignWare core IP.
Signed-off-by: Vidya Sagar <vidyas@xxxxxxxxxx>
---
V2:
* Addressed review comment from Rob
.../bindings/pci/nvidia,tegra194-pcie.txt | 104 +++++++++++++++++-
1 file changed, 101 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/pci/nvidia,tegra194-pcie.txt b/Documentation/devicetree/bindings/pci/nvidia,tegra194-pcie.txt
index 8e4f9bfb316d..d6f4ea783b00 100644
--- a/Documentation/devicetree/bindings/pci/nvidia,tegra194-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/nvidia,tegra194-pcie.txt
@@ -10,6 +10,8 @@ Required properties:
- power-domains: A phandle to the node that controls power to the respective
PCIe controller and a specifier name for the PCIe controller. Following are
the specifiers for the different PCIe controllers
+ Tegra194:
+ ---------
TEGRA194_POWER_DOMAIN_PCIEX8B: C0
TEGRA194_POWER_DOMAIN_PCIEX1A: C1
TEGRA194_POWER_DOMAIN_PCIEX1A: C2
@@ -18,6 +20,21 @@ Required properties:
TEGRA194_POWER_DOMAIN_PCIEX8A: C5
these specifiers are defined in
"include/dt-bindings/power/tegra194-powergate.h" file.
+ Tegra234:
+ ---------
+ TEGRA234_POWER_DOMAIN_PCIEX4BA: C0
+ TEGRA234_POWER_DOMAIN_PCIEX1A : C1
+ TEGRA234_POWER_DOMAIN_PCIEX1A : C2
+ TEGRA234_POWER_DOMAIN_PCIEX1A : C3
+ TEGRA234_POWER_DOMAIN_PCIEX4BB: C4
+ TEGRA234_POWER_DOMAIN_PCIEX8A : C5
+ TEGRA234_POWER_DOMAIN_PCIEX4A : C6
+ TEGRA234_POWER_DOMAIN_PCIEX8B : C7
+ TEGRA234_POWER_DOMAIN_PCIEX4CA: C8
+ TEGRA234_POWER_DOMAIN_PCIEX4CB: C9
+ TEGRA234_POWER_DOMAIN_PCIEX4CC: C10
+ these specifiers are defined in
+ "include/dt-bindings/power/tegra234-powergate.h" file.
- reg: A list of physical base address and length pairs for each set of
controller registers. Must contain an entry for each entry in the reg-names
property.
@@ -47,16 +64,33 @@ Required properties:
"p2u-N": where N ranges from 0 to one less than the total number of lanes
- nvidia,bpmp: Must contain a pair of phandle to BPMP controller node followed
by controller-id. Following are the controller ids for each controller.
+ Tegra194:
+ ---------
0: C0
1: C1
2: C2
3: C3
4: C4
5: C5
+ Tegra194:
+ ---------
+ 0 : C0
+ 1 : C1
+ 2 : C2
+ 3 : C3
+ 4 : C4
+ 5 : C5
+ 6 : C6
+ 7 : C7
+ 8 : C8
+ 9 : C9
+ 10: C10
- vddio-pex-ctl-supply: Regulator supply for PCIe side band signals
RC mode:
-- compatible: Tegra19x must contain "nvidia,tegra194-pcie"
+- compatible: Must be
+ - "nvidia,tegra194-pcie" for Tegra194
+ - "nvidia,tegra234-pcie" for Tegra234
- device_type: Must be "pci" for RC mode
- interrupt-names: Must include the following entries:
"msi": The Tegra interrupt that is asserted when an MSI is received
@@ -99,7 +133,8 @@ In Tegra194, Only controllers C0, C4 & C5 support EP mode.
Optional properties:
- pinctrl-names: A list of pinctrl state names.
- It is mandatory for C5 controller and optional for other controllers.
+ It is mandatory for C5 controller in Tegra194 and optional for other
+ controllers.
- "default": Configures PCIe I/O for proper operation.
- pinctrl-0: phandle for the 'default' state of pin configuration.
It is mandatory for C5 controller and optional for other controllers.
@@ -108,7 +143,7 @@ Optional properties:
improve performance when a platform is designed in such a way that it
satisfies at least one of the following conditions thereby enabling root
port to exchange optimum number of FC (Flow Control) credits with
- downstream devices
+ downstream devices. This is applicable for only Tegra194.
1. If C0/C4/C5 run at x1/x2 link widths (irrespective of speed and MPS)
2. If C0/C1/C2/C3/C4/C5 operate at their respective max link widths and
a) speed is Gen-2 and MPS is 256B
@@ -119,6 +154,9 @@ Optional properties:
specified in microseconds
- nvidia,aspm-l0s-entrance-latency-us: ASPM L0s entrance latency to be
specified in microseconds
+- nvidia,enable-srns: This boolean property needs to be present if the
+ controller is configured to operate in SRNS (Separate Reference Clocks with
+ No Spread-Spectrum Clocking). This is applicable only for Tegra234.
RC mode:
- vpcie3v3-supply: A phandle to the regulator node that supplies 3.3V to the slot
@@ -127,6 +165,9 @@ RC mode:
- vpcie12v-supply: A phandle to the regulator node that supplies 12V to the slot
if the platform has one such slot. (Ex:- x16 slot owned by C5 controller
in p2972-0000 platform).
+- nvidia,enable-ext-refclk: This boolean property needs to be present if the
+ controller is configured to use the reference clocking coming in from an
+ external clock source instead of using the internal clock source.
EP mode:
- nvidia,refclk-select-gpios: Must contain a phandle to a GPIO controller
@@ -243,3 +284,60 @@ Tegra194 EP mode:
phy-names = "p2u-0", "p2u-1", "p2u-2", "p2u-3", "p2u-4",
"p2u-5", "p2u-6", "p2u-7";
};
+
+Tegra234 RP mode:
+-----------------
+
+ pcie@141a0000 {
+ compatible = "nvidia,tegra234-pcie";
+ power-domains = <&bpmp TEGRA234_POWER_DOMAIN_PCIEX8A>;
+ reg = <0x00 0x141a0000 0x0 0x00020000>, /* appl registers (128K) */
+ <0x00 0x3a000000 0x0 0x00040000>, /* configuration space (256K) */
+ <0x00 0x3a040000 0x0 0x00040000>, /* iATU_DMA reg space (256K) */
+ <0x00 0x3a080000 0x0 0x00040000>; /* DBI reg space (256K) */
+ reg-names = "appl", "config", "atu_dma", "dbi";
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ device_type = "pci";
+ num-lanes = <8>;
+ num-viewport = <8>;
+ linux,pci-domain = <5>;
+
+ clocks = <&bpmp TEGRA234_CLK_PEX1_C5_CORE>;
+ clock-names = "core";
+
+ resets = <&bpmp TEGRA234_RESET_PEX1_CORE_5_APB>,
+ <&bpmp TEGRA234_RESET_PEX1_CORE_5>;
+ reset-names = "apb", "core";
+
+ interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>, /* controller interrupt */
+ <GIC_SPI 54 IRQ_TYPE_LEVEL_HIGH>; /* MSI interrupt */
+ interrupt-names = "intr", "msi";
+
+ #interrupt-cells = <1>;
+ interrupt-map-mask = <0 0 0 0>;
+ interrupt-map = <0 0 0 0 &gic GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>;
+
+ nvidia,bpmp = <&bpmp 5>;
+
+ nvidia,aspm-cmrt-us = <60>;
+ nvidia,aspm-pwr-on-t-us = <20>;
+ nvidia,aspm-l0s-entrance-latency-us = <3>;
+
+ bus-range = <0x0 0xff>;
+
+ ranges = <0x43000000 0x27 0x40000000 0x27 0x40000000 0x3 0xe8000000>, /* prefetchable memory (16000 MB) */
+ <0x02000000 0x0 0x40000000 0x2b 0x28000000 0x0 0x08000000>, /* non-prefetchable memory (128 MB) */
+ <0x01000000 0x0 0x3a100000 0x00 0x3a100000 0x0 0x00100000>; /* downstream I/O (1 MB) */
+
+ interconnects = <&mc TEGRA234_MEMORY_CLIENT_PCIE5R &emc>,
+ <&mc TEGRA234_MEMORY_CLIENT_PCIE5W &emc>;
+ interconnect-names = "dma-mem", "write";
+
+ phys = <&p2u_nvhs_0>, <&p2u_nvhs_1>, <&p2u_nvhs_2>,
+ <&p2u_nvhs_3>, <&p2u_nvhs_4>, <&p2u_nvhs_5>,
+ <&p2u_nvhs_6>, <&p2u_nvhs_7>;
+ phy-names = "p2u-0", "p2u-1", "p2u-2", "p2u-3", "p2u-4",
+ "p2u-5", "p2u-6", "p2u-7";
+ };
--
2.17.1
