On Sat 18 Dec 06:10 PST 2021, Dmitry Baryshkov wrote:
> Add optional interconnect support for the 2.7.0/1.9.0 hosts. Set the
> bandwidth according to the values from the downstream driver.
>
What memory transactions will travel this path? I would expect there to
be two different paths involved, given the rather low bw numbers I
presume this is the config path?
Is there no vote for the data path?
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> ---
> drivers/pci/controller/dwc/pcie-qcom.c | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index d8d400423a0a..55ac3caa6d7d 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -12,6 +12,7 @@
> #include <linux/crc8.h>
> #include <linux/delay.h>
> #include <linux/gpio/consumer.h>
> +#include <linux/interconnect.h>
> #include <linux/interrupt.h>
> #include <linux/io.h>
> #include <linux/iopoll.h>
> @@ -167,6 +168,7 @@ struct qcom_pcie_resources_2_7_0 {
> struct clk *pipe_clk_src;
> struct clk *phy_pipe_clk;
> struct clk *ref_clk_src;
> + struct icc_path *path;
> };
>
> union qcom_pcie_resources {
> @@ -1121,6 +1123,10 @@ static int qcom_pcie_get_resources_2_7_0(struct qcom_pcie *pcie)
> if (IS_ERR(res->pci_reset))
> return PTR_ERR(res->pci_reset);
>
> + res->path = devm_of_icc_get(dev, "pci");
The paths are typically identified using a string of the form
<source>-<destination>.
I don't see the related update to the DT binding for the introduction of
the interconnect.
Regards,
Bjorn
> + if (IS_ERR(res->path))
> + return PTR_ERR(res->path);
> +
> res->supplies[0].supply = "vdda";
> res->supplies[1].supply = "vddpe-3v3";
> ret = devm_regulator_bulk_get(dev, ARRAY_SIZE(res->supplies),
> @@ -1183,6 +1189,9 @@ static int qcom_pcie_init_2_7_0(struct qcom_pcie *pcie)
> if (pcie->cfg->pipe_clk_need_muxing)
> clk_set_parent(res->pipe_clk_src, res->phy_pipe_clk);
>
> + if (res->path)
> + icc_set_bw(res->path, 500, 800);
> +
> ret = clk_bulk_prepare_enable(res->num_clks, res->clks);
> if (ret < 0)
> goto err_disable_regulators;
> @@ -1241,6 +1250,8 @@ static void qcom_pcie_deinit_2_7_0(struct qcom_pcie *pcie)
> struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
>
> clk_bulk_disable_unprepare(res->num_clks, res->clks);
> + if (res->path)
> + icc_set_bw(res->path, 0, 0);
>
> /* Set TCXO as clock source for pcie_pipe_clk_src */
> if (pcie->cfg->pipe_clk_need_muxing)
> --
> 2.34.1
>
