From: Pali Rohár <pali@xxxxxxxxxx>
Currently enabling PCI_EXP_RTSTA_PME bit in PCI_EXP_RTCTL register does
nothing. This is because PCIe PME driver expects to receive PCIe interrupt
defined in PCI_EXP_FLAGS_IRQ register, but aardvark hardware does not
trigger PCIe INTx/MSI interrupt for PME event, rather it triggers custom
aardvark interrupt which this driver is not processing yet.
Fix this issue by handling PME interrupt in advk_pcie_handle_int() and
chaining it to PCIe interrupt 0 with generic_handle_domain_irq() (since
aardvark sets PCI_EXP_FLAGS_IRQ to zero). With this change PCIe PME driver
finally starts receiving PME interrupt.
Signed-off-by: Pali Rohár <pali@xxxxxxxxxx>
Signed-off-by: Marek Behún <kabel@xxxxxxxxxx>
---
drivers/pci/controller/pci-aardvark.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
index e7b9ca31c79c..3f2d570bfbb5 100644
--- a/drivers/pci/controller/pci-aardvark.c
+++ b/drivers/pci/controller/pci-aardvark.c
@@ -1487,6 +1487,18 @@ static void advk_pcie_handle_int(struct advk_pcie *pcie)
isr1_mask = advk_readl(pcie, PCIE_ISR1_MASK_REG);
isr1_status = isr1_val & ((~isr1_mask) & PCIE_ISR1_ALL_MASK);
+ /* Process PME interrupt */
+ if (isr0_status & PCIE_MSG_PM_PME_MASK) {
+ /*
+ * Do not clear PME interrupt bit in ISR0, it is cleared by IRQ
+ * receiver by writing to the PCI_EXP_RTSTA register of emulated
+ * root bridge. Aardvark HW returns zero for PCI_EXP_FLAGS_IRQ,
+ * so use PCIe interrupt 0.
+ */
+ if (generic_handle_domain_irq(pcie->irq_domain, 0) == -EINVAL)
+ dev_err_ratelimited(&pcie->pdev->dev, "unhandled PME IRQ\n");
+ }
+
/* Process ERR interrupt */
if (isr0_status & PCIE_ISR0_ERR_MASK) {
advk_writel(pcie, PCIE_ISR0_ERR_MASK, PCIE_ISR0_REG);
--
2.34.1
