From: Pali Rohár <pali@xxxxxxxxxx> ERR interrupt is triggered when corresponding bit is unmasked in both ISR0 and PCI_EXP_DEVCTL registers. Unmasking ERR bits in PCI_EXP_DEVCTL register is not enough. This means that currently the ERR interrupt is never triggered. Unmask ERR bits in ISR0 register at driver probe time. ERR interrupt is not triggered until ERR bits are unmasked also in PCI_EXP_DEVCTL register, which is done by AER driver. So it is safe to unconditionally unmask all ERR bits in aardvark probe. Aardvark HW sets PCI_ERR_ROOT_AER_IRQ to zero and when corresponding bits in ISR0 and PCI_EXP_DEVCTL are enabled, the HW triggers a generic interrupt on GIC. Chain this interrupt to PCIe interrupt 0 with generic_handle_domain_irq() to allow processing of ERR interrupts. Signed-off-by: Pali Rohár <pali@xxxxxxxxxx> Signed-off-by: Marek Behún <kabel@xxxxxxxxxx> --- drivers/pci/controller/pci-aardvark.c | 35 ++++++++++++++++++++++++++- 1 file changed, 34 insertions(+), 1 deletion(-) diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c index 24c67dc983e5..d5dcb3322d56 100644 --- a/drivers/pci/controller/pci-aardvark.c +++ b/drivers/pci/controller/pci-aardvark.c @@ -103,6 +103,10 @@ #define PCIE_MSG_PM_PME_MASK BIT(7) #define PCIE_ISR0_MASK_REG (CONTROL_BASE_ADDR + 0x44) #define PCIE_ISR0_MSI_INT_PENDING BIT(24) +#define PCIE_ISR0_CORR_ERR BIT(11) +#define PCIE_ISR0_NFAT_ERR BIT(12) +#define PCIE_ISR0_FAT_ERR BIT(13) +#define PCIE_ISR0_ERR_MASK GENMASK(13, 11) #define PCIE_ISR0_INTX_ASSERT(val) BIT(16 + (val)) #define PCIE_ISR0_INTX_DEASSERT(val) BIT(20 + (val)) #define PCIE_ISR0_ALL_MASK GENMASK(31, 0) @@ -790,11 +794,15 @@ advk_pci_bridge_emul_base_conf_read(struct pci_bridge_emul *bridge, case PCI_INTERRUPT_LINE: { /* * From the whole 32bit register we support reading from HW only - * one bit: PCI_BRIDGE_CTL_BUS_RESET. + * two bits: PCI_BRIDGE_CTL_BUS_RESET and PCI_BRIDGE_CTL_SERR. * Other bits are retrieved only from emulated config buffer. */ __le32 *cfgspace = (__le32 *)&bridge->conf; u32 val = le32_to_cpu(cfgspace[PCI_INTERRUPT_LINE / 4]); + if (advk_readl(pcie, PCIE_ISR0_MASK_REG) & PCIE_ISR0_ERR_MASK) + val &= ~(PCI_BRIDGE_CTL_SERR << 16); + else + val |= PCI_BRIDGE_CTL_SERR << 16; if (advk_readl(pcie, PCIE_CORE_CTRL1_REG) & HOT_RESET_GEN) val |= PCI_BRIDGE_CTL_BUS_RESET << 16; else @@ -824,6 +832,19 @@ advk_pci_bridge_emul_base_conf_write(struct pci_bridge_emul *bridge, break; case PCI_INTERRUPT_LINE: + /* + * According to Figure 6-3: Pseudo Logic Diagram for Error + * Message Controls in PCIe base specification, SERR# Enable bit + * in Bridge Control register enable receiving of ERR_* messages + */ + if (mask & (PCI_BRIDGE_CTL_SERR << 16)) { + u32 val = advk_readl(pcie, PCIE_ISR0_MASK_REG); + if (new & (PCI_BRIDGE_CTL_SERR << 16)) + val &= ~PCIE_ISR0_ERR_MASK; + else + val |= PCIE_ISR0_ERR_MASK; + advk_writel(pcie, val, PCIE_ISR0_MASK_REG); + } if (mask & (PCI_BRIDGE_CTL_BUS_RESET << 16)) { u32 val = advk_readl(pcie, PCIE_CORE_CTRL1_REG); if (new & (PCI_BRIDGE_CTL_BUS_RESET << 16)) @@ -1470,6 +1491,18 @@ static void advk_pcie_handle_int(struct advk_pcie *pcie) isr1_mask = advk_readl(pcie, PCIE_ISR1_MASK_REG); isr1_status = isr1_val & ((~isr1_mask) & PCIE_ISR1_ALL_MASK); + /* Process ERR interrupt */ + if (isr0_status & PCIE_ISR0_ERR_MASK) { + advk_writel(pcie, PCIE_ISR0_ERR_MASK, PCIE_ISR0_REG); + + /* + * Aardvark HW returns zero for PCI_ERR_ROOT_AER_IRQ, so use + * PCIe interrupt 0 + */ + if (generic_handle_domain_irq(pcie->irq_domain, 0) == -EINVAL) + dev_err_ratelimited(&pcie->pdev->dev, "unhandled ERR IRQ\n"); + } + /* Process MSI interrupts */ if (isr0_status & PCIE_ISR0_MSI_INT_PENDING) advk_pcie_handle_msi(pcie); -- 2.32.0