An MMIO read from a PCI device that doesn't exist or doesn't respond causes a PCI error. There's no real data to return to satisfy the CPU read, so most hardware fabricates ~0 data. Use SET_PCI_ERROR_RESPONSE() to set the error response, when a faulty read occurs. This helps unify PCI error response checking and make error check consistent and easier to find. Compile tested only. Signed-off-by: Naveen Naidu <naveennaidu479@xxxxxxxxx> --- drivers/pci/controller/pcie-rockchip-host.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/pci/controller/pcie-rockchip-host.c b/drivers/pci/controller/pcie-rockchip-host.c index c52316d0bfd2..f5d718700d59 100644 --- a/drivers/pci/controller/pcie-rockchip-host.c +++ b/drivers/pci/controller/pcie-rockchip-host.c @@ -222,7 +222,7 @@ static int rockchip_pcie_rd_conf(struct pci_bus *bus, u32 devfn, int where, struct rockchip_pcie *rockchip = bus->sysdata; if (!rockchip_pcie_valid_device(rockchip, bus, PCI_SLOT(devfn))) { - *val = 0xffffffff; + SET_PCI_ERROR_RESPONSE(val); return PCIBIOS_DEVICE_NOT_FOUND; } -- 2.25.1