The :doc:`foo` tag is auto-generated via automarkup.py.
So, use the filename at the sources, instead of :doc:`foo`.
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
---
Documentation/PCI/pci.rst | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/Documentation/PCI/pci.rst b/Documentation/PCI/pci.rst
index 814b40f8360b..fa651e25d98c 100644
--- a/Documentation/PCI/pci.rst
+++ b/Documentation/PCI/pci.rst
@@ -265,7 +265,7 @@ Set the DMA mask size
---------------------
.. note::
If anything below doesn't make sense, please refer to
- :doc:`/core-api/dma-api`. This section is just a reminder that
+ Documentation/core-api/dma-api.rst. This section is just a reminder that
drivers need to indicate DMA capabilities of the device and is not
an authoritative source for DMA interfaces.
@@ -291,7 +291,7 @@ Many 64-bit "PCI" devices (before PCI-X) and some PCI-X devices are
Setup shared control data
-------------------------
Once the DMA masks are set, the driver can allocate "consistent" (a.k.a. shared)
-memory. See :doc:`/core-api/dma-api` for a full description of
+memory. See Documentation/core-api/dma-api.rst for a full description of
the DMA APIs. This section is just a reminder that it needs to be done
before enabling DMA on the device.
@@ -421,7 +421,7 @@ owners if there is one.
Then clean up "consistent" buffers which contain the control data.
-See :doc:`/core-api/dma-api` for details on unmapping interfaces.
+See Documentation/core-api/dma-api.rst for details on unmapping interfaces.
Unregister from other subsystems
--
2.31.1
