This Broadcom STB has one port and connects directly to one device, be it a
switch or an endpoint. We want to be able to turn on/off any regulators
for that device. Control of regulators is needed because of the
chicken-and-egg situation: although the regulator is "owned" by the device
and would be best handled by its driver, the device cannot be discovered
and probed unless its regulator is already turned on.
Signed-off-by: Jim Quinlan <jim2101024@xxxxxxxxx>
---
drivers/pci/controller/pcie-brcmstb.c | 83 +++++++++++++++++++++++++--
1 file changed, 78 insertions(+), 5 deletions(-)
diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index 4ce1f3a60574..1b0de0c7da60 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -24,6 +24,7 @@
#include <linux/pci.h>
#include <linux/pci-ecam.h>
#include <linux/printk.h>
+#include <linux/regulator/consumer.h>
#include <linux/reset.h>
#include <linux/sizes.h>
#include <linux/slab.h>
@@ -169,6 +170,7 @@
#define SSC_STATUS_SSC_MASK 0x400
#define SSC_STATUS_PLL_LOCK_MASK 0x800
#define PCIE_BRCM_MAX_MEMC 3
+#define PCIE_BRCM_MAX_EP_REGULATORS 4
#define IDX_ADDR(pcie) (pcie->reg_offsets[EXT_CFG_INDEX])
#define DATA_ADDR(pcie) (pcie->reg_offsets[EXT_CFG_DATA])
@@ -192,6 +194,11 @@ static inline void brcm_pcie_perst_set_4908(struct brcm_pcie *pcie, u32 val);
static inline void brcm_pcie_perst_set_7278(struct brcm_pcie *pcie, u32 val);
static inline void brcm_pcie_perst_set_generic(struct brcm_pcie *pcie, u32 val);
+static const char * const supplies[] = {
+ "vpcie12v-supply",
+ "vpcie3v3-supply",
+};
+
enum {
RGR1_SW_INIT_1,
EXT_CFG_INDEX,
@@ -295,8 +302,27 @@ struct brcm_pcie {
u32 hw_rev;
void (*perst_set)(struct brcm_pcie *pcie, u32 val);
void (*bridge_sw_init_set)(struct brcm_pcie *pcie, u32 val);
+ struct regulator_bulk_data supplies[PCIE_BRCM_MAX_EP_REGULATORS];
+ unsigned int num_supplies;
};
+static int brcm_set_regulators(struct brcm_pcie *pcie, bool on)
+{
+ struct device *dev = pcie->dev;
+ int ret;
+
+ if (!pcie->num_supplies)
+ return 0;
+ if (on)
+ ret = regulator_bulk_enable(pcie->num_supplies, pcie->supplies);
+ else
+ ret = regulator_bulk_disable(pcie->num_supplies, pcie->supplies);
+ if (ret)
+ dev_err(dev, "failed to %s EP regulators\n",
+ on ? "enable" : "disable");
+ return ret;
+}
+
/*
* This is to convert the size of the inbound "BAR" region to the
* non-linear values of PCIE_X_MISC_RC_BAR[123]_CONFIG_LO.SIZE
@@ -1112,9 +1138,10 @@ static inline int brcm_phy_start(struct brcm_pcie *pcie)
return pcie->rescal ? brcm_phy_cntl(pcie, 1) : 0;
}
-static inline int brcm_phy_stop(struct brcm_pcie *pcie)
+static inline void brcm_phy_stop(struct brcm_pcie *pcie)
{
- return pcie->rescal ? brcm_phy_cntl(pcie, 0) : 0;
+ if (pcie->rescal)
+ brcm_phy_cntl(pcie, 0);
}
static void brcm_pcie_turn_off(struct brcm_pcie *pcie)
@@ -1141,16 +1168,45 @@ static void brcm_pcie_turn_off(struct brcm_pcie *pcie)
pcie->bridge_sw_init_set(pcie, 1);
}
+static int brcm_pcie_get_regulators(struct brcm_pcie *pcie)
+{
+ struct device_node *np = pcie->np;
+ struct property *pp;
+ const unsigned int ns = ARRAY_SIZE(supplies);
+ unsigned int i;
+ int ret = 0;
+
+ /* Look for specific pcie regulators in the RC DT node. */
+ for_each_property_of_node(np, pp) {
+ for (i = 0; i < ns; i++)
+ if (strcmp(supplies[i], pp->name) == 0)
+ break;
+ if (i >= ns)
+ continue;
+
+ if (pcie->num_supplies < PCIE_BRCM_MAX_EP_REGULATORS)
+ pcie->supplies[pcie->num_supplies++].supply
+ = supplies[i];
+ else
+ dev_warn(pcie->dev, "No room for supply %s\n",
+ supplies[i]);
+ }
+
+ if (pcie->num_supplies)
+ ret = devm_regulator_bulk_get(pcie->dev, pcie->num_supplies,
+ pcie->supplies);
+ return ret;
+}
+
static int brcm_pcie_suspend(struct device *dev)
{
struct brcm_pcie *pcie = dev_get_drvdata(dev);
- int ret;
brcm_pcie_turn_off(pcie);
- ret = brcm_phy_stop(pcie);
+ brcm_phy_stop(pcie);
clk_disable_unprepare(pcie->clk);
- return ret;
+ return brcm_set_regulators(pcie, false);
}
static int brcm_pcie_resume(struct device *dev)
@@ -1165,6 +1221,10 @@ static int brcm_pcie_resume(struct device *dev)
if (ret)
return ret;
+ ret = brcm_set_regulators(pcie, true);
+ if (ret)
+ return ret;
+
ret = brcm_phy_start(pcie);
if (ret)
goto err;
@@ -1201,6 +1261,7 @@ static void __brcm_pcie_remove(struct brcm_pcie *pcie)
brcm_phy_stop(pcie);
reset_control_assert(pcie->rescal);
clk_disable_unprepare(pcie->clk);
+ brcm_set_regulators(pcie, false);
}
static int brcm_pcie_remove(struct platform_device *pdev)
@@ -1291,6 +1352,18 @@ static int brcm_pcie_probe(struct platform_device *pdev)
return ret;
}
+ ret = brcm_pcie_get_regulators(pcie);
+ if (ret) {
+ pcie->num_supplies = 0;
+ if (ret != -EPROBE_DEFER)
+ dev_err(pcie->dev, "failed to get regulators (err=%d)\n", ret);
+ goto fail;
+ }
+
+ ret = brcm_set_regulators(pcie, true);
+ if (ret)
+ goto fail;
+
ret = brcm_pcie_setup(pcie);
if (ret)
goto fail;
--
2.17.1
