Hi,
> > topology that DT modification will not work and still I have no device
> > node.
>
> I'm absolutely not a DT expert, but I assume that a thermal zone would
> be associated with some resource fixed by the platform, such as a fan,
> so I would think a thermal zone would have to be described in terms of
> the platform physical topology, not the PCI device type.
The thermal zone needs a temperature sensor device to read out
temperature and also some cooling devices which are mapped to specific
zone trips.
In a below scenario, when TZ hists the wifi_allert0 trip it will run
the fan but if the temp still rises it will try to dissipate the heat
by running some actions within wifi adapter eg. switch off some
antennas.
[...]
wifi_thermal: wifi-thermal {
thermal-sensors = <&wifi_device>;
trips {
wifi_alert0: wifi-alert0 {
temperature = <90000>;
hysteresis = <5000>;
type = "active";
};
wifi_alert1: wifi-alert1 {
temperature = <110000>;
hysteresis = <5000>;
type = "passive";
};
cooling-maps {
map0 {
trip = <&wifi_alert0>;
cooling-device = <&fan0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
};
map1 {
trip = <&wifi_alert1>;
cooling-device = <&wifi_device THERMAL_NO_LIMIT
THERMAL_NO_LIMIT>;
};
};
};
[...]
My problem is not a cooling method but the binding of the PCI device
(it has a thermal sensor) with the thermal zone
thermal-sensors = <&wifi_device>; // wifi_devcie does not
exist until I will statically define it under PCI controller
The point here is that defining wifi_device under the controller I
need to reflect the PCI topology. Which is fair as DT should reflect
the HW connection. Even if I define a wifi_device anywhere in DT and
assuming the PCI core will search whole DT and not only subnodes of
the controller/bridge/switch here likely comes another problem. What
should be the key to search for the device node? PCI addresses devices
by bus:device: function and this is known after PCI scan.
To me seems that so far no one found a good way to handle thermal
within PCI devices, so some drivers statically create TZ and handle it
within the driver. This way, unfortunately, we lose the flexibility of
thermal control from a system-wide perspective. WiFi adapter is not
aware of the fan for example.
/Waldek
