On Thu, Jan 14, 2021 at 9:06 PM Leon Romanovsky <leon@xxxxxxxxxx> wrote:
>
> On Thu, Jan 14, 2021 at 08:00:50PM +0800, Hongtao Wu wrote:
> > On Thu, Jan 14, 2021 at 4:52 PM Leon Romanovsky <leon@xxxxxxxxxx> wrote:
> > >
> > > On Thu, Jan 14, 2021 at 04:29:28PM +0800, Hongtao Wu wrote:
> > > > From: Hongtao Wu <billows.wu@xxxxxxxxxx>
> > > >
> > > > This series adds PCIe controller driver for Unisoc SoCs.
> > > > This controller is based on DesignWare PCIe IP.
> > > >
> > > > Signed-off-by: Hongtao Wu <billows.wu@xxxxxxxxxx>
> > > > ---
> > > > drivers/pci/controller/dwc/Kconfig | 12 ++
> > > > drivers/pci/controller/dwc/Makefile | 1 +
> > > > drivers/pci/controller/dwc/pcie-sprd.c | 293 +++++++++++++++++++++++++++++++++
> > > > 3 files changed, 306 insertions(+)
> > > > create mode 100644 drivers/pci/controller/dwc/pcie-sprd.c
> > >
> > > <...>
> > >
> > > > +static struct platform_driver sprd_pcie_driver = {
> > > > + .probe = sprd_pcie_probe,
> > > > + .remove = __exit_p(sprd_pcie_remove),
> > > ^^^^^^ why is that?
> > >
> >
> > Thanks for the review.
> >
> > I think that if 'MODULE' is defined, '.remove = sprd_pcie_remove',
> > else '.remove = NULL'.
> > I would appreciate hearing your opinion about this.
>
> If module not defined, these .probe and .remove won't be called.
>
> >
> > > > + .driver = {
> > > > + .name = "sprd-pcie",
> > > > + .of_match_table = sprd_pcie_of_match,
> > > > + },
> > > > +};
> > > > +
> > > > +module_platform_driver(sprd_pcie_driver);
> > > > +
> > > > +MODULE_DESCRIPTION("Unisoc PCIe host controller driver");
> > > > +MODULE_LICENSE("GPL v2");
> > >
> > > I think that it needs to be "GPL" and not "GPL v2".
> > >
> >
> > Many platform drivers use 'GPL v2', but others use 'GPL'.
> > I am not sure whether to use 'GPL' or 'GPL v2'.
> > Could you tell me why ‘GPL’ is needed here?
>
> Because GPL already means v2, see Documentation/process/license-rules.rst
>
> 447
> 448 "GPL v2" Same as "GPL". It exists for historic
> 449 reasons.
>
Thanks for the explanation!
I'll update “GPL” and ".remove" in the next version.
>
> >
> > > Thanks
> > >
> > > > --
> > > > 2.7.4
> > > >
