If we fail to assign resources to a PCI BAR, this patch makes us try the original address from BIOS rather than leaving it disabled. Linux tries to make sure all PCI device BARs are inside the upstream PCI host bridge or P2P bridge apertures, reassigning BARs if necessary. Windows does similar reassignment. Before this patch, if we could not move a BAR into an aperture, we left the resource unassigned, i.e., at address zero. Windows leaves such BARs at the original BIOS addresses, and this patch makes Linux do the same. This is a bit ugly because we disable the resource long before we try to reassign it, so we have to keep track of the BIOS BAR address somewhere. For lack of a better place, I put it in the struct pci_dev. I think it would be cleaner to attempt the assignment immediately when the claim fails, so we could easily remember the original address. But we currently claim motherboard resources in the middle, after attempting to claim PCI resources and before assigning new PCI resources, and changing that is a fairly big job. Addresses https://bugzilla.kernel.org/show_bug.cgi?id=16263 Reported-by: Andrew <nitr0@xxxxxxxxxx> Tested-by: Andrew <nitr0@xxxxxxxxxx> Signed-off-by: Bjorn Helgaas <bjorn.helgaas@xxxxxx> --- arch/x86/pci/i386.c | 1 + drivers/pci/setup-res.c | 32 ++++++++++++++++++++++++++++++++ include/linux/pci.h | 1 + 3 files changed, 34 insertions(+), 0 deletions(-) diff --git a/arch/x86/pci/i386.c b/arch/x86/pci/i386.c index 6fdb3ec..5525309 100644 --- a/arch/x86/pci/i386.c +++ b/arch/x86/pci/i386.c @@ -184,6 +184,7 @@ static void __init pcibios_allocate_resources(int pass) idx, r, disabled, pass); if (pci_claim_resource(dev, idx) < 0) { /* We'll assign a new address later */ + dev->fw_addr[idx] = r->start; r->end -= r->start; r->start = 0; } diff --git a/drivers/pci/setup-res.c b/drivers/pci/setup-res.c index 92379e2..2aaa131 100644 --- a/drivers/pci/setup-res.c +++ b/drivers/pci/setup-res.c @@ -156,6 +156,38 @@ static int __pci_assign_resource(struct pci_bus *bus, struct pci_dev *dev, pcibios_align_resource, dev); } + if (ret < 0 && dev->fw_addr[resno]) { + struct resource *root, *conflict; + resource_size_t start, end; + + /* + * If we failed to assign anything, let's try the address + * where firmware left it. That at least has a chance of + * working, which is better than just leaving it disabled. + */ + + if (res->flags & IORESOURCE_IO) + root = &ioport_resource; + else + root = &iomem_resource; + + start = res->start; + end = res->end; + res->start = dev->fw_addr[resno]; + res->end = res->start + size - 1; + dev_info(&dev->dev, "BAR %d: trying firmware assignment %pR\n", + resno, res); + conflict = request_resource_conflict(root, res); + if (conflict) { + dev_info(&dev->dev, + "BAR %d: %pR conflicts with %s %pR\n", resno, + res, conflict->name, conflict); + res->start = start; + res->end = end; + } else + ret = 0; + } + if (!ret) { res->flags &= ~IORESOURCE_STARTALIGN; dev_info(&dev->dev, "BAR %d: assigned %pR\n", resno, res); diff --git a/include/linux/pci.h b/include/linux/pci.h index 7cb0084..f26fda7 100644 --- a/include/linux/pci.h +++ b/include/linux/pci.h @@ -288,6 +288,7 @@ struct pci_dev { */ unsigned int irq; struct resource resource[DEVICE_COUNT_RESOURCE]; /* I/O and memory regions + expansion ROMs */ + resource_size_t fw_addr[DEVICE_COUNT_RESOURCE]; /* FW-assigned addr */ /* These fields are used by common fixups */ unsigned int transparent:1; /* Transparent PCI bridge */ -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
