Yinghai Lu wrote:
On 01/12/2010 04:50 PM, Kenji Kaneshige wrote:
Yinghai Lu wrote:
for pciehp to use it later
pci_setup_bridge() will not check enabled for the slot bridge, otherwise
update res is not updated to bridge BAR. that is bridge is enabled already for
port service.
-v2: update it with resource_list_x
Signed-off-by: Yinghai Lu <yinghai@xxxxxxxxxx>
...
+
+void pci_assign_unassigned_bridge_resources(struct pci_dev *bridge)
+{
+ struct pci_bus *bus;
+ struct pci_bus *parent = bridge->subordinate;
+ int retval;
+
+ pci_bus_size_bridges(parent);
+ pci_clear_master(bridge);
I have a concern about clearing bus master enable bit here, though
I'm not sure about it. I'm wondering if clearing bus master enable
bit might have some bad effect for the port services to work. For
example, does MSI interrupt work without enabling bus mastering?
but we set that pci_set_master right away after we assign the new resource
Yes, I know you set bus master enable bit again.
In my understanding, bus master enable bit of the bridge is
cleared temporary while its port service driver is working.
I'm worrying about this temporary operation. For example,
I'm worrying about whether the MSI interrupt works, if some
port service generates interrupts when bus master enable bit
is cleared temporary.
Thanks,
Kenji Kaneshige
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
