Clean up some stray whitespace issues.
Signed-off-by: Alex Chiang <achiang@xxxxxx>
---
drivers/pci/pci-sysfs.c | 18 +++++++++---------
drivers/pci/probe.c | 24 +++++++++++++-----------
drivers/pci/remove.c | 4 ++--
3 files changed, 24 insertions(+), 22 deletions(-)
diff --git a/drivers/pci/pci-sysfs.c b/drivers/pci/pci-sysfs.c
index dcbc8bc..adc6b86 100644
--- a/drivers/pci/pci-sysfs.c
+++ b/drivers/pci/pci-sysfs.c
@@ -10,7 +10,7 @@
*
* File attributes for PCI devices
*
- * Modeled after usb's driverfs.c
+ * Modeled after usb's driverfs.c
*
*/
@@ -70,7 +70,7 @@ static ssize_t broken_parity_status_store(struct device *dev,
static ssize_t local_cpus_show(struct device *dev,
struct device_attribute *attr, char *buf)
-{
+{
const struct cpumask *mask;
int len;
@@ -380,13 +380,13 @@ pci_write_config(struct kobject *kobj, struct bin_attribute *bin_attr,
size = dev->cfg_size - off;
count = size;
}
-
+
if ((off & 1) && size) {
pci_user_write_config_byte(dev, off, data[off - init_off]);
off++;
size--;
}
-
+
if ((off & 3) && size > 2) {
u16 val = data[off - init_off];
val |= (u16) data[off - init_off + 1] << 8;
@@ -404,7 +404,7 @@ pci_write_config(struct kobject *kobj, struct bin_attribute *bin_attr,
off += 4;
size -= 4;
}
-
+
if (size >= 2) {
u16 val = data[off - init_off];
val |= (u16) data[off - init_off + 1] << 8;
@@ -818,21 +818,21 @@ pci_read_rom(struct kobject *kobj, struct bin_attribute *bin_attr,
if (!pdev->rom_attr_enabled)
return -EINVAL;
-
+
rom = pci_map_rom(pdev, &size); /* size starts out as PCI window size */
if (!rom)
return 0;
-
+
if (off >= size)
count = 0;
else {
if (off + count > size)
count = size - off;
-
+
memcpy_fromio(buf, rom + off, count);
}
pci_unmap_rom(pdev, rom);
-
+
return count;
}
diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c
index 9cf810e..7399d4e 100644
--- a/drivers/pci/probe.c
+++ b/drivers/pci/probe.c
@@ -494,7 +494,7 @@ int __devinit pci_scan_bridge(struct pci_bus *bus, struct pci_dev *dev, int max,
}
/* Disable MasterAbortMode during probing to avoid reporting
- of bus errors (in some architectures) */
+ of bus errors (in some architectures) */
pci_read_config_word(dev, PCI_BRIDGE_CONTROL, &bctl);
pci_write_config_word(dev, PCI_BRIDGE_CONTROL,
bctl & ~PCI_BRIDGE_CTL_MASTER_ABORT);
@@ -570,7 +570,7 @@ int __devinit pci_scan_bridge(struct pci_bus *bus, struct pci_dev *dev, int max,
buses &= ~0xff000000;
buses |= CARDBUS_LATENCY_TIMER << 24;
}
-
+
/*
* We need to blast all three values with a single write.
*/
@@ -680,7 +680,7 @@ static void pci_read_irq(struct pci_dev *dev)
* pci_setup_device - fill in class and map information of a device
* @dev: the device structure to fill
*
- * Initialize the device structure with information about the device's
+ * Initialize the device structure with information about the device's
* vendor,class,memory and IO-space addresses,IRQ lines etc.
* Called at initialisation of the PCI subsystem and by CardBus services.
* Returns 0 on success and -1 if unknown type of device (not normal, bridge
@@ -720,8 +720,8 @@ static int pci_setup_device(struct pci_dev * dev)
pci_read_config_word(dev, PCI_SUBSYSTEM_ID, &dev->subsystem_device);
/*
- * Do the ugly legacy mode stuff here rather than broken chip
- * quirk code. Legacy mode ATA controllers have fixed
+ * Do the ugly legacy mode stuff here rather than broken
+ * chip quirk code. Legacy mode ATA controllers have fixed
* addresses. These are not always echoed in BAR0-3, and
* BAR0-3 in a few cases contain junk!
*/
@@ -752,7 +752,7 @@ static int pci_setup_device(struct pci_dev * dev)
goto bad;
/* The PCI-to-PCI bridge spec requires that subtractive
decoding (i.e. transparent) bridge must have programming
- interface code of 0x01. */
+ interface code of 0x01. */
pci_read_irq(dev);
dev->transparent = ((dev->class & 0xff) == 1);
pci_read_bases(dev, 2, PCI_ROM_ADDRESS1);
@@ -1051,14 +1051,14 @@ int pci_scan_slot(struct pci_bus *bus, int devfn)
nr++;
/*
- * If this is a single function device,
- * don't scan past the first function.
- */
+ * If this is a single function device,
+ * don't scan past the first function.
+ */
if (!dev->multifunction) {
if (func > 0) {
dev->multifunction = 1;
} else {
- break;
+ break;
}
}
} else {
@@ -1140,7 +1140,9 @@ struct pci_bus * pci_create_bus(struct device *parent,
b->ops = ops;
if (pci_find_bus(pci_domain_nr(b), bus)) {
- /* If we already got to this bus through a different bridge, ignore it */
+ /* If we already got to this bus through a different bridge,
+ * ignore it
+ */
pr_debug("PCI: Bus %04x:%02x already known\n", pci_domain_nr(b), bus);
goto err_out;
}
diff --git a/drivers/pci/remove.c b/drivers/pci/remove.c
index 042e089..ba58128 100644
--- a/drivers/pci/remove.c
+++ b/drivers/pci/remove.c
@@ -7,7 +7,7 @@ static void pci_free_resources(struct pci_dev *dev)
{
int i;
- msi_remove_pci_irq_vectors(dev);
+ msi_remove_pci_irq_vectors(dev);
pci_cleanup_rom(dev);
for (i = 0; i < PCI_NUM_RESOURCES; i++) {
@@ -49,7 +49,7 @@ static void pci_destroy_dev(struct pci_dev *dev)
* pci_remove_device_safe - remove an unused hotplug device
* @dev: the device to remove
*
- * Delete the device structure from the device lists and
+ * Delete the device structure from the device lists and
* notify userspace (/sbin/hotplug), but only if the device
* in question is not being used by a driver.
* Returns 0 on success.
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
