Hello all, On Wed, Nov 26, 2008 at 7:26 PM, Leon Woestenberg <leon.woestenberg@xxxxxxxxx> wrote: > On Wed, Nov 26, 2008 at 4:25 PM, Leon Woestenberg > <leon.woestenberg@xxxxxxxxx> wrote: >> The non-detected end point boot: >> >> pci 0001:80:00.0: scanning behind bridge, config bf8180, pass 0 >> PCI: Scanning bus 0001:81 >> PCI: Fixups for bus 0001:81 >> Progress on this issue: I found out that re-programming the end point FPGA again *just* after *uboot* read it, and before Linux kernel has started, makes the end point appear properly. Either u-boot leaves the end point in bad state, or the root complex reset also requires an end point reset. (or a third option I could not think of yet). I'll pick this up on ppc and u-boot mailing list with new info, especially with the ppc4xx maintainers. Consider this thread closed. Thanks for ignoring my ranting :-) Regards, -- Leon -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
