I noticed the following scsi boot issues with v4.13.7: [ 8.961944] scsi 3:0:0:0: Direct-Access WD My Passport 0748 1022 PQ: 0 ANSI: 6 [ 8.964334] scsi 3:0:0:1: Enclosure WD SES Device 1022 PQ: 0 ANSI: 6 [ 9.062546] sd 3:0:0:0: [sda] Spinning up disk... [ 10.080033] .[ 10.436010] scsi 2:0:0:0: Direct-Access SEAGATE ST3300007LC D705 PQ : 0 ANSI: 3 [ 10.436010] scsi target2:0:0: tagged command queuing enabled, command queue depth 16. [ 10.436010] scsi target2:0:0: Beginning Domain Validation [ 10.443210] scsi target2:0:0: FAST-80 WIDE SCSI 160.0 MB/s DT (12.5 ns, offset 31) [ 10.451755] scsi target2:0:0: Ending Domain Validation [ 10.453274] sd 2:0:0:0: [sdb] 585937500 512-byte logical blocks: (300 GB/279 GiB) [ 10.458212] sd 2:0:0:0: [sdb] Write Protect is off [ 10.458212] sd 2:0:0:0: [sdb] Mode Sense: ab 00 10 08 [ 10.460232] sd 2:0:0:0: [sdb] Write cache: disabled, read cache: enabled, supports DPO and FUA [ 10.493071] sdb: sdb1 [ 10.528764] sd 2:0:0:0: [sdb] Attached SCSI disk [ 12.053526] scsi 3:0:0:1: Wrong diagnostic page; asked for 1 got 8 [ 12.053707] scsi 3:0:0:1: Failed to get diagnostic page 0xffffffea [ 12.053696] ready [ 12.054129] scsi 3:0:0:1: Failed to bind enclosure -19 [ 12.054363] ses 3:0:0:1: Attached Enclosure device [ 12.054495] sd 3:0:0:0: [sda] 3906963456 512-byte logical blocks: (2.00 TB/1.82 TiB) [ 12.062494] sd 3:0:0:0: [sda] Write Protect is off [ 12.062494] sd 3:0:0:0: [sda] Mode Sense: 47 00 10 08[ 12.063619] sd 3:0:0:0: [sda] No Caching mode page found [ 12.066860] sd 3:0:0:0: [sda] Assuming drive cache: write through [ 12.104257] sda: sda1 sda2 [ 12.151862] sd 3:0:0:0: [sda] Attached SCSI disk Haven't seen this before. Dave -- John David Anglin dave.anglin@xxxxxxxx -- To unsubscribe from this list: send the line "unsubscribe linux-parisc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
