From: Phillip Raffeck <phillip.raffeck@xxxxxx>
This patch removes the macro SERIAL_DEBUG_PNP, which is used to enable debugging
at compile time. As SERIAL_DEBUG_PNP is an orphan, the corresponding #ifdef is
removed. To keep the ability to enable debugging at compile time, the call to
printk(KERN_DEBUG ...) is replaced by a corresponding call to dev_dbg(), which
is configurable via CONFIG_DYNAMIC_DEBUG.
Signed-off-by: Phillip Raffeck <phillip.raffeck@xxxxxx>
Signed-off-by: Anton Würfel <anton.wuerfel@xxxxxx>
CC: linux-kernel@xxxxxxxxxxxx
---
v3: Remove orphaned macro as suggested by Andy
---
drivers/tty/serial/8250/8250_pnp.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_pnp.c b/drivers/tty/serial/8250/8250_pnp.c
index ffa7354..5f852e8 100644
--- a/drivers/tty/serial/8250/8250_pnp.c
+++ b/drivers/tty/serial/8250/8250_pnp.c
@@ -464,11 +464,11 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
} else
return -ENODEV;
-#ifdef SERIAL_DEBUG_PNP
- printk(KERN_DEBUG
- "Setup PNP port: port %x, mem 0x%lx, irq %d, type %d\n",
- uart.port.iobase, uart.port.mapbase, uart.port.irq, uart.port.iotype);
-#endif
+ dev_debug(&dev->dev,
+ "Setup PNP port: port %x, mem 0x%lx, irq %d, type %d\n",
+ uart.port.iobase, uart.port.mapbase,
+ uart.port.irq, uart.port.iotype);
+
if (flags & CIR_PORT) {
uart.port.flags |= UPF_FIXED_PORT | UPF_FIXED_TYPE;
uart.port.type = PORT_8250_CIR;
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-parisc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
