> On Mon, Dec 17, 2007 at 11:20:15PM -0500, John David Anglin wrote:
> > > you need -rc5, iirc i put some changes i nthere too.
Tried -rc6. It also crashed on boot. Console log is below.
Dave
--
J. David Anglin dave.anglin@xxxxxxxxxxxxxx
National Research Council of Canada (613) 990-0752 (FAX: 952-6602)
Boot IO Dependent Code (IODC) revision 1
HARD Booted.
palo ipl 1.14 root@duet Sat Apr 8 16:08:16 EDT 2006
Partition Start(MB) End(MB) Id Type
1 1 191 f0 Palo
2 192 1526 82 swap
3 1527 34732 83 ext2
PALO(F0) partition contains:
PALO is formatted EXT2/3
Command line for kernel: ' root=/dev/sda3 console=ttyS0 palo_kernel=1/vmlinux'
Selected kernel: /vmlinux from partition 1
Selected ramdisk: /initrd.img from partition 1
ELF64 executable
Entry 00100000 first 00100000 n 2
Segment 0 load 00100000 size 5013504 mediaptr 0x1000
Segment 1 load 00608000 size 566144 mediaptr 0x4c9000
Loading ramdisk 3388537 bytes @ 3fcb3000...
Branching to kernel entry point 0x00100000. If this is the last
message you see, you may need to switch your console. This is
a common symptom -- search the FAQ and mailing list at parisc-linux.org
Linux version 2.6.24-rc6 (dave@gsyprf11) (gcc version 4.2.3 20071123 (prerelease) (Debian 4.2.2-4)) #1 SMP Fri Dec 21 19:07:38 PST 2007
FP[0] enabled: Rev 1 Model 19
The 64-bit Kernel has started...
console [ttyB0] enabled
Initialized PDC Console for debugging.
Determining PDC firmware type: 64 bit PAT.
model 00005e30 00000491 00000000 00000001 312b7146 100000f0 00000008 000000b2 000000b2
vers 00000203
CPUID vers 19 rev 8 (0x00000268)
capabilities 0x5
model 9000/800/A500-7X
Memory Ranges:
0) Start 0x0000000000000000 End 0x00000000efffffff Size 3840 MB
1) Start 0x0000000100000000 End 0x00000001ffffffff Size 4096 MB
2) Start 0x00000010f0000000 End 0x00000010ffffffff Size 256 MB
Total Memory: 8192 MB
initrd: 7fcb3000-7ffee479
initrd: reserving 3fcb3000-3ffee479 (mem_max 200000000)
SMP: bootstrap CPU ID is 0
Built 3 zonelists in Zone order, mobility grouping on. Total pages: 2068480
Kernel command line: root=/dev/sda3 console=ttyS0 palo_kernel=1/vmlinux
PID hash table entries: 4096 (order: 12, 32768 bytes)
Console: colour dummy device 160x64
Dentry cache hash table entries: 1048576 (order: 11, 8388608 bytes)
Inode-cache hash table entries: 524288 (order: 10, 4194304 bytes)
Memory: 8234192k/8388608k available (3309k kernel code, 152804k reserved, 1538k data, 188k init)
virtual kernel memory layout:
vmalloc : 0x0000000000008000 - 0x000000003f000000 (1007 MB)
memory : 0x0000000040000000 - 0x0000001140000000 (69632 MB)
.init : 0x0000000040664000 - 0x0000000040693000 ( 188 kB)
.data : 0x000000004043b568 - 0x00000000405bc000 (1538 kB)
.text : 0x0000000040100000 - 0x000000004043b568 (3309 kB)
Mount-cache hash table entries: 256
Brought up 1 CPUs
net_namespace: 120 bytes
NET: Registered protocol family 16
Searching for devices...
Found devices:
1. Crescendo 750 W2 at 0xfffffffffffa0000 [160] { 0, 0x0, 0x5e3, 0x00004 }
2. Crescendo 750 W2 at 0xfffffffffffa2000 [162] { 0, 0x0, 0x5e3, 0x00004 }
3. Memory at 0xfffffffffed08000 [8] { 1, 0x0, 0x09b, 0x00009 }
4. Astro BC Runway Port at 0xfffffffffed00000 [0] { 12, 0x0, 0x582, 0x0000b }
5. Elroy PCI Bridge at 0xfffffffffed30000 [0/0] { 13, 0x0, 0x782, 0x0000a }
6. Elroy PCI Bridge at 0xfffffffffed34000 [0/2] { 13, 0x0, 0x782, 0x0000a }
7. Elroy PCI Bridge at 0xfffffffffed38000 [0/4] { 13, 0x0, 0x782, 0x0000a }
8. Elroy PCI Bridge at
********** VIRTUAL FRONT PANEL **********
System Boot detected
*****************************************
LEDs: RUN ATTENTION FAULT REMOTE POWER
ON FLASH OFF ON ON
LED State: There was a system interruption that did not take the system down.
Check Chassis and Console Logs for error messages.
processor system initialization 1C00
*****************************************
************ EARLY BOOT VFP *************
End of early boot detected
*****************************************
********** VIRTUAL FRONT PANEL **********
System Boot detected
*****************************************
LEDs: RUN ATTENTION FAULT REMOTE POWER
ON FLASH FLASH ON ON
LED State: System Running. Unexpected Reboot. Non-critical Error Detected.
Check Chassis and Console Logs for error messages.
processor system panic 1B00
***** EARLY BOOT VFP : SYSTEM ALERT *****
SYSTEM NAME: gsyprf11c
DATE: 12/22/2007 TIME: 03:45:54
ALERT LEVEL: 12 = Software failure
REASON FOR ALERT
SOURCE: 1 = processor
SOURCE DETAIL: 1 = processor general SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail
LEDs: RUN ATTENTION FAULT REMOTE POWER
ON FLASH FLASH ON ON
LED State: System Running. Unexpected Reboot. Non-critical Error Detected.
Check Chassis and Console Logs for error messages.
0xA0E000C01100B009 00000000 00000520 - type 20 = major change in system state
0x58E008C01100B009 00006B0B 16032D36 - type 11 = Timestamp 12/22/2007 03:45:54
A/a: ack read of this entry - Q/q: quit Virtual Front Panel Display
Anything else redisplay the log entry
->Choice:Timeout!
*****************************************
***** EARLY BOOT VFP : SYSTEM ALERT *****
SYSTEM NAME: gsyprf11c
DATE: 12/22/2007 TIME: 03:45:55
ALERT LEVEL: 12 = Software failure
REASON FOR ALERT
SOURCE: 1 = processor
SOURCE DETAIL: 1 = processor general SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail
LEDs: RUN ATTENTION FAULT REMOTE POWER
ON FLASH FLASH ON ON
LED State: System Running. Unexpected Reboot. Non-critical Error Detected.
Check Chassis and Console Logs for error messages.
0xA0E000C01100B009 00000000 00000520 - type 20 = major change in system state
0x58E008C01100B009 00006B0B 16032D37 - type 11 = Timestamp 12/22/2007 03:45:55
A/a: ack read of this entry - Q/q: quit Virtual Front Panel Display
Anything else redisplay the log entry
-
To unsubscribe from this list: send the line "unsubscribe linux-parisc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
