On Tuesday 12 November 2013 01:36 AM, Andreas Fenkart wrote:
For now, only support SDIO interrupt if we are booted with
DT. This is because some platforms need special quirks. And
we don't want to add new legacy mux platform init code
callbacks any longer as we are moving to DT based booting
anyways.
Broken hardware, missing the swakueup line, should fallback
to polling, by setting 'ti,quirk-swakup-missing' in the
device tree. Otherwise pending SDIO IRQ are not detected
while in suspend. This affects am33xx processors.
For the DT-Binding portion:
Reviewed-by: Grant Likely <grant.likely@xxxxxxxxxxxx>
Acked-by: Kumar Gala <galak@xxxxxxxxxxxxxx>
Signed-off-by: Andreas Fenkart <afenkart@xxxxxxxxx>
---
.../devicetree/bindings/mmc/ti-omap-hsmmc.txt | 18 ++++
drivers/mmc/host/omap_hsmmc.c | 86 ++++++++++++++++++--
2 files changed, 95 insertions(+), 9 deletions(-)
+static void omap_hsmmc_enable_sdio_irq(struct mmc_host *mmc, int enable)
+{
+ struct omap_hsmmc_host *host = mmc_priv(mmc);
+ u32 irq_mask;
+ unsigned long flags;
+
+ spin_lock_irqsave(&host->irq_lock, flags);
+
Hi Andreas,
Thanks for the patch,
You don't check for runtime pm status here before read/write to HSMMC registers,
can you please explain ?
+ irq_mask = OMAP_HSMMC_READ(host->base, ISE);
+ if (enable) {
+ host->flags |= HSMMC_SDIO_IRQ_ENABLED;
+ irq_mask |= CIRQ_EN;
+ } else {
+ host->flags &= ~HSMMC_SDIO_IRQ_ENABLED;
+ irq_mask &= ~CIRQ_EN;
+ }
+ OMAP_HSMMC_WRITE(host->base, IE, irq_mask);
+
+ /*
+ * if enable, piggy back detection on current request
+ * but always disable immediately
+ */
+ if (!host->req_in_progress || !enable)
+ OMAP_HSMMC_WRITE(host->base, ISE, irq_mask);
+
+ /* flush posted write */
+ OMAP_HSMMC_READ(host->base, IE);
+
+ spin_unlock_irqrestore(&host->irq_lock, flags);
+}
+
static void omap_hsmmc_conf_bus_power(struct omap_hsmmc_host *host)
{
u32 hctl, capa, value;
@@ -1635,7 +1687,7 @@ static const struct mmc_host_ops omap_hsmmc_ops = {
.get_cd = omap_hsmmc_get_cd,
.get_ro = omap_hsmmc_get_ro,
.init_card = omap_hsmmc_init_card,
- /* NYET -- enable_sdio_irq */
+ .enable_sdio_irq = omap_hsmmc_enable_sdio_irq,
};
#ifdef CONFIG_DEBUG_FS
@@ -2021,6 +2073,22 @@ static int omap_hsmmc_probe(struct platform_device *pdev)
dev_warn(&pdev->dev,
"pins are not configured from the driver\n");
+ /*
+ * For now, only support SDIO interrupt if we are booted with
+ * DT. This is because some platforms need special quirks. And
+ * we don't want to add new legacy mux platform init code
+ * callbacks any longer as we are moving to DT based booting
+ * anyways.
+ */
+ if (pdev->dev.of_node) {
+ mmc->caps |= MMC_CAP_SDIO_IRQ;
+ if (of_find_property(host->dev->of_node,
+ "ti,quirk-swakeup-missing", NULL)) {
+ /* no wakeup from deeper power states, use polling */
+ mmc->caps &= ~MMC_CAP_SDIO_IRQ;
+ }
+ }
+
omap_hsmmc_protect_card(host);
mmc_add_host(mmc);
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
