Re: [PATCH v2 2/5] ARM: dts: omap: Add new bindings for OMAP

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



+ A couple of DT maintainers

On 09/10/2013 18:41, Rajendra Nayak wrote:
On Wednesday 09 October 2013 08:43 PM, Benoit Cousson wrote:
Hi Rajendra,

On 09/10/2013 12:11, Rajendra Nayak wrote:
On OMAP we have co-processor IPs, memory controllers,
GPIOs which control regulators and power switches to
PMIC, and SoC internal Bus IPs, some or most of which
should either not be reset or idled or both at init.
(In some cases there are erratas which prevent an IP
from being reset)
Have a way to pass this information from DT.

Did you get some acked-by from the DT maintainers?
Every new bindings must be carefully reviewed now.

Nope, I haven't. The patches are on the list for a couple
of months now.

Let's see if Mark and Rob are OK with that.

Thanks,
Benoit



Regards,
Benoit


Update the am33xx/omap4 and omap5 dtsi files with the
new bindings for modules which either should not be
idled. reset or both. A later patch would cleanup the
same information that exists today as part of the hwmod
data files.

Signed-off-by: Rajendra Nayak <rnayak@xxxxxx>
---
   .../devicetree/bindings/arm/omap/omap.txt          |    3 ++-
   arch/arm/boot/dts/am33xx.dtsi                      |    2 ++
   arch/arm/boot/dts/omap4.dtsi                       |    3 +++
   arch/arm/boot/dts/omap5.dtsi                       |    2 ++
   4 files changed, 9 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/arm/omap/omap.txt b/Documentation/devicetree/bindings/arm/omap/omap.txt
index 91b7049..808c154 100644
--- a/Documentation/devicetree/bindings/arm/omap/omap.txt
+++ b/Documentation/devicetree/bindings/arm/omap/omap.txt
@@ -21,7 +21,8 @@ Required properties:
   Optional properties:
   - ti,no_idle_on_suspend: When present, it prevents the PM to idle the module
     during suspend.
-
+- ti,no-reset-on-init: When present, the module should not be reset at init
+- ti,no-idle-on-init: When present, the module should not be idled at init

   Example:

diff --git a/arch/arm/boot/dts/am33xx.dtsi b/arch/arm/boot/dts/am33xx.dtsi
index f9c5da9..ec33ea0 100644
--- a/arch/arm/boot/dts/am33xx.dtsi
+++ b/arch/arm/boot/dts/am33xx.dtsi
@@ -607,6 +607,7 @@
               reg = <0x44d00000 0x4000    /* M3 UMEM */
                      0x44d80000 0x2000>;    /* M3 DMEM */
               ti,hwmods = "wkup_m3";
+            ti,no-reset-on-init;
           };

           elm: elm@48080000 {
@@ -637,6 +638,7 @@
           gpmc: gpmc@50000000 {
               compatible = "ti,am3352-gpmc";
               ti,hwmods = "gpmc";
+            ti,no-idle-on-init;
               reg = <0x50000000 0x2000>;
               interrupts = <100>;
               gpmc,num-cs = <7>;
diff --git a/arch/arm/boot/dts/omap4.dtsi b/arch/arm/boot/dts/omap4.dtsi
index 22d9f2b..e8fe797 100644
--- a/arch/arm/boot/dts/omap4.dtsi
+++ b/arch/arm/boot/dts/omap4.dtsi
@@ -214,6 +214,7 @@
               gpmc,num-cs = <8>;
               gpmc,num-waitpins = <4>;
               ti,hwmods = "gpmc";
+            ti,no-idle-on-init;
           };

           uart1: serial@4806a000 {
@@ -492,6 +493,7 @@
               reg = <0x4c000000 0x100>;
               interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_HIGH>;
               ti,hwmods = "emif1";
+            ti,no-idle-on-init;
               phy-type = <1>;
               hw-caps-read-idle-ctrl;
               hw-caps-ll-interface;
@@ -503,6 +505,7 @@
               reg = <0x4d000000 0x100>;
               interrupts = <GIC_SPI 111 IRQ_TYPE_LEVEL_HIGH>;
               ti,hwmods = "emif2";
+            ti,no-idle-on-init;
               phy-type = <1>;
               hw-caps-read-idle-ctrl;
               hw-caps-ll-interface;
diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
index 7cdea1b..a9d49df 100644
--- a/arch/arm/boot/dts/omap5.dtsi
+++ b/arch/arm/boot/dts/omap5.dtsi
@@ -607,6 +607,7 @@
           emif1: emif@0x4c000000 {
               compatible    = "ti,emif-4d5";
               ti,hwmods    = "emif1";
+            ti,no-idle-on-init;
               phy-type    = <2>; /* DDR PHY type: Intelli PHY */
               reg = <0x4c000000 0x400>;
               interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_HIGH>;
@@ -618,6 +619,7 @@
           emif2: emif@0x4d000000 {
               compatible    = "ti,emif-4d5";
               ti,hwmods    = "emif2";
+            ti,no-idle-on-init;
               phy-type    = <2>; /* DDR PHY type: Intelli PHY */
               reg = <0x4d000000 0x400>;
               interrupts = <GIC_SPI 111 IRQ_TYPE_LEVEL_HIGH>;




--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux Arm (vger)]     [ARM Kernel]     [ARM MSM]     [Linux Tegra]     [Linux WPAN Networking]     [Linux Wireless Networking]     [Maemo Users]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Trails]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux