On 08/11/2013 06:53 AM, Daniel Mack wrote:
Hi Dave,
Thanks a lot for your work on this.
On 06.08.2013 19:49, Dave Gerlach wrote:
This is the third version of the patch series for adding basic suspend-resume
support for AM33XX, previously submitted by Vaibhav Bedia. This patchset
is based on 3.11-rc4 and depends on a forthcoming patchset from Suman Anna
that adds mailbox support for the wkup_m3. The patches at [1], [2], and [3] are
required for the pm code to properly suspend and resume.
I applied your set and the one from Suman Anna, and with musb disabled
and the firmware built from the sources you referenced, I'm able to put
a custom AM33xx based board to suspend.
The problem I currently face is that I can't make the board resume, as
neither UART0 nor GPIO0 seem to work as wakeup source.
Did you apply the other patches that are mentioned besides Suman's
series? The board will hang while suspending without these.
Which wakeup source did you use in your tests?
Most of my verification was done with UART wakeup.
Thanks,
Daniel
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
